
BURE ORTHO/SPACE
GATERD.SE6
8. Maintenance
Recommended at least once per year.
Check that Action
General
The walker feels rm/free from play.
The walker does not rattle during manoeuvres.
The walker is level and all of its castors are in contact with
the oor.
The walker is not dirty.
Clean with lukewarm soap solution or alcohol-based
cleaning agent (no petroleum products).
Armrests
Arm rests are intact and clean.
Arm restwidening is functional.
Clean; replace if damaged.
Fit lock knobs/plates as required
Handtag
Grips are not damaged/dirty.
Handle adjustment is functional.
Clean with lukewarm soap solution (no petroleum
products).
Replace handle grips.
Fit lock knobs/plates as required.
Battery
Check that the charging cable is connected to the control
box.
Check that the remote control is connected to the control
box.
Check that connections are made according to the wiring
diagram.
Check that the battery, actuators and control box are not
loose.
Fit new cable; this must always be connected to the control
box (IP65 classication).
Connect or t new remote control as required.
Refer to the wiring diagram in the Technical manual.
Tighten; replace with new fasteners as required.
Height adjustment
Raising and lowering are functional.
The walker feels stable at maximum settings.
There is no play between the vertical frame and bottom
frame.
Height adjustment clamps lock.
The electric actuator tting must be free from play. Height
adjustment via remote control is functional. The electric
actuator must run smoothly at a constant speed.
Fit new guide sleeves (in frame) or end plugs (in chrome
tubes) as required.
Tighten all lock bolts.
Replace clamps.
Tighten the attachment tting concerned; replace bolts/
lock nuts as necessary.
Check that the battery/remote control/ actuator are
connected in accordance with the wiring diagram. Charge
the battery. Contact customer services.
Frame parts
There is no mechanical damage.
There are no scratches.
End plugs/lower frame tted.
If damage is present, contact GATE’s customer
services.
Touch up as necessary.
Fit new end plugs.
Castors/brakes
Castors roll easily/tread not damaged.
The castors are tightly fastened to the lower frame.
Castor brakes functional on all castors.
Handbrake functional.
Clean or replace castors (NOTE: Castors are
always xed to the lower frame with thread locker
or lock nuts. The castors are sealed and we do not
recommend their dismantling; instead, replace the
whole castor assembly.
Tighten the castor bolt and t locking nut or use
thread locker (depends on model).
Replace castor assembly.
Adjust the brake or t new castors.