GE Tetra GEPS24-100U-GL User manual

• Supports Tetra PowerStrip DS, Tetra miniStrip DS, Tetra EdgeStrip,
Tetra Contour and Tetra Contour LS LED lighting systems
• UL: Class 2 wiring per NEC Article 725, dry and damp location rated
• IEC: SELV, CE: IP66 rated, separate enclosure required
(GEPS24-100U-GL)
Tetra® LED Systems Power Supply
24
Volt
GE
Lighting Solutions
Installation Guide
imagination at work
Power Supply Features
RISK OF ELECTRIC SHOCK:
• Disconnect power at fuse box or circuit breaker before servicing or
installing product.
• Properly ground Tetra® power supply.
RISK OF FIRE:
• Use only Tetra® supply wire to make connection from Tetra® power
supply to Tetra® LED strip.
• Use only approved wire for input/output connection.
Minimum size 18 AWG (0.82 mm2)
• Follow all local codes.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation électrique à la boîte de fusibles ou au
disjoncteur avant l’entretien ou l’installation du produit.
• Assurez-vous de correctement mettre à terre l’alimentation
électrique Tetra®.
RISQUES D’INCENDIE
• N’utilisez que le l d’approvisionnement Tetra® pour faire la
connexion entre l’alimentation Tetra® et la bande DEL Tetra®.
• N’utilisez que des ls approuvés pour les entrées/sorties de
connexion. Taille minimum 18 AWG (0.82 mm2).
• Respectez tous les codes locaux.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
Power Supply Installation
1Connect the AC line to the brown
(line) and blue (neutral) input
wires of the power supply using
18-14 AWG (0.82-2.08 mm2) or
18-10 AWG (0.82-5.26 mm2) twist-on
wire connectors.
Connect the supply wire that is
attached to the Tetra LED System to
the red (+) and black (-) output wires
of the power supply as outlined
in the “Electrical Connections”
section of your LED system’s
Installation Instructions.
2
Input
wires
Blue (neutral)
Brown (line)
AC line
To Tetra LED System
Output
wires
Red (+)
Black (-)

SIGN112-R112612
Power Supply Specications
*Maximum case temperature is 85°C
Performance Data Min Typical Max
Input Voltage (VAC) 108 120-277 305
Input Frequency (Hz) - 50/60 -
Input Current (A) 0.35 - 1.1
Output Voltage (VDC) 23 24 25
Output Current (ADC) - - 4.0
Output Power (W) - - 96
Environmental Operating Temperature Range -40°C +25°C +55°C*
Environmental Humidity (non-condensing) 0% - 95%
Environmental Storage Temperature Range -40°C - +85°C
Dimensions 9.5 in. x 1.7 in. x 1.2 in. (241 mm x 43.2 mm x 30.5 mm)
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelightingsolutions.com
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Tetra is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
© 2012 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
NOTE: For CSA approval, a disconnect/toggle switch of appropriate rating needs to be placed within 29.5 ft. (9 m) of primary side of the
power supply. The minimum rating of the switch must be either 120 or 220 Volts AC. The switch must also support twice the amount of
input current.
NOTE: When installing power supply, connect to the appropriate sized building breaker or disconnect device for line and neutral
connections, in accordance with local, state or country regulations.
NOTE: The grounding and bonding of the power supply and overall sign shall be done in accordance with National Electric Code (NEC)
Article 600.
GEPS24-100U-GL
Supports
Tetra Products SKUs
Rated
Watts
Maximum Load
per Power Supply
Remote Mounting Distance
18 AWG/
0.82 mm2
16 AWG/
1.31 mm2
14 AWG/
2.08 mm2
12 AWG/
3.31 mm2
Tetra
PowerStrip DS
GEWHDSPS6, GEWWDSPS6-50K,
GEWWDSPS6-41K, GEWWDSPS6 6W/mod 16 modules/ 22.0 ft. (6.71m) 20 ft./6.1m 25 ft./7.6m 35 ft./10.6m 40 ft./12.1m
Tetra
miniStrip DS
GEWHBDP6, GEWWBDP6-50K,
GEWWBDP6-41K, GEWWBDP6 2.2W/mod 39 modules/ 39 ft. (11.89m) 20 ft./6.1m 25 ft./7.6m 35 ft./10.6m 40 ft./12.1m
Tetra
EdgeStrip
GEWHBIP2, GEWWBIP2-50K,
GEWWBIP2-41K, GEWWBIP2 2.4W/mod 37 modules/ 37 ft. (11.28m) 20 ft./6.1m 25 ft./7.6m 35 ft./10.6m 40 ft./12.1m
Tetra
Contour LS
GEWHXNLA2-WH, GEBLXNLA2-BL,
GEGLXNLA2-GL, GERDXNLA2-RD,
GEWHXNAA2-WH, GEBLXNAA2-BL,
GEGLXNAA2-GL, GERDXNAA2-RD
3.2W/ft. 29 ft. (8.84m) 30 ft./9.1m 50 ft./15.2m 80 ft./24.4m 120 ft./36.6m
Tetra Contour GEWHXNLE1, GEWWXNLE1, GEBLXNLE1,
GEGLXNLE1, GERDXNLE1, GERCXNLE1,
GEYAXNLE1
3.2W/ft. 29 ft. (8.84m) 30 ft./9.1m 50 ft./15.2m 80 ft./24.4m 120 ft./36.6m
Conforms to the following standards: