Gedore RTU 1 User manual

How to adjust your RTU
To check setting:
Use a Torque analyser
To adjust the torque setting:
1. Remove o-ring, retaining pin and hexagon adaptor.
2. Using of 5mm hexagon key, turn ANTICLOCKWISE to release.
3. Remove the 5mm hexagon key, and insert 4mm hexagon key.
4. Turn the 4mm hexagon key CLOCKWISE to INCREASE torque, or
ANTI-CLOCKWISE to REDUCE the torque.
5. Remove 4mm hexagon key and check the torque setting on a
suitable calibration device.
6. Insert 5mm hexagon key, and turn CLOCKWISE to lock off.
7. Replace hexagon adaptor, retaining pin and o-ring.
Servicing Information
Regular servicing of your Torque Tool by competent personnel is important to
ensure it continues to perform correctly.
HEXAGON ADAPTER
O-RING
RETAINING PIN

How to use and care for your RTU
Tool Specification:
Models:
Range:
Maximum Speed:
RTU 1
0.1 –1Nm
500 revs/min
RTU 4
0.6 –4.5Nm
500 revs/min
RTU 14
2 –14Nm
125 revs/min
Repeatability: +/- 6% of Torque Setting
ISO 6789 Class: Type 2, Class F
Calibration Period: Every 12 Months or 5000 cycles minimum
Mechanism: Slipping - Incorrect tightening is impossible
Safety & Maintenance
This Torque Tool is a precision instrument and should be used for its
intended purpose only
Only hold the tool using the handgrip
Always ensure that the tool is in correct alignment with the fastener
Torque tools should be regularly calibrated and inspected to ensure
correct operation
Ensure the tool is clean and free from oil, grease and water before use
Never dip into cleaning fluid or petroleum