Geemarc Ampli550 User manual

Ampli550/500+
Digital Amplified Telephone
GEEMARC QUICK REFERENCE
AND INSTALLATION GUIDE
Unpack all phone components and be sure nothing is missing
Connect as shown below
Phone should have power and signal
See the back of this guide for basic operation
Refer to the owners manual for additional detail

Ampli550/500+
Digital Amplified Telephone
GEEMARC QUICK REFERENCE
AND INSTALLATION GUIDE
On the side edge of the phone are plus and minus buttons
for the ringer volume. Adjust these to the desired setting.
Note that there is an input jack and switch for an optional
Sonic Shaker for notification through vibration.
At the bottom of the phone below the number pad are
adjustments for handset volume and tone. Once a call has
been received, adjust by sliding the knob left or right to your
individual preference.
Ringer / Indicator Handset Volume & Tone
Programming Numbers
One-Touch Calls
To program a number (at standby mode):
Dial the number
Long press PROG followed by the location, M1 through M6
Press Save soft key
Press Save soft key again after name stored
Press Select soft key .
Using the same procedure, you can also program one-touch
emergency numbers in the P1 and P2 locations.
To make a call using the one-touch function, simply lift the
handset, or press the speaker button, and press the desired
button, M1-M6 or P1-P2, and the call will be completed as you
previously programmed (a simple slide out sheet is on the right
edge of the phone for you to write your stored numbers).
Because the phone has such capability, we included the
CS button – Customer Service – if you should have any
questions or require support for operation. That number
is 888.864.2446 and can be programmed at the green
CS location.