Geemarc CL100 User manual

CL100
English

2
!!!User manual to read carefully before start to
use!!!
!!!Manueld’utilisationàlireimpérativementavant
la mise en service!!!
!!!BevorIhrneuesTelefongerätzubenutzen,
bittelesenSiediesBenutzerhandbuch sehr
sorgfältig!!!
CAUTION: thistelephoneisspecificallydesignedforthepeoplewithhearing
difficultiesandisprovidedwithahandsetearpiecevolumecontrolforindividual
requirements. Due care must be taken by all users that the handset earpiece
volume control is set to the lowest level acceptable by each respective user.
Careshould therefore beexercisedto ensure thatanynaive users arefamiliar
withthisrequirement.
ATTENTION: Ce téléphone peut être destiné aux personnes ayant des
problèmes auditifs. il possède un écouteur a volume variable. A la première
utilisation,assurezvous que le volumesoitrégléau minimum. Les personnes
malentendantespourrontparlasuite augmenterlevolumepourl’adapter àleur
besoin.
WARNUNG:DiesesTelefonwurdespeziellfürschwerhörigePersonen
konzipiertund besitzteineauf dieindividuellenBedürfnisse einstellbare
Hörerlautstärke.InFolge dessen solltenalleNutzer darauf achten, dassder
LautstärkereglerdesHörers, in Rücksichtaufandere Nutzer,aufdas
niedrigste Niveau gestellt wird. Es ist darauf zu achten, dass unwissende
Benutzermit derHandhabung dieserApparaturvertraut gemachtwerden.

3
Index
Description 4
Setting up 7
-Connectingthetelephone 7
-Ringervolumesetting 7
-Tone/Pulse switch 8
-Time breack recall setting 8
-Wallmounting 8
Volume and tone adjustment 10
-Receivingvolumeandtoneadjustment 10
-Sendingvolumeadjustment 12
Using the phone 13
- Answer a call 13
- Making a call 13
-Last numberredial 14
- Recall, * & # buttons 14
-Mutebutton 14
-Storingtelephonenumbers 15
-Diallingstorednumber 16
Generalinformations 17

4
Description
Receptiontone
adjustment
Lastnumberredial
Memorystoring
Mute
Flashingincomingring indicator
Direct memories
3emergency
numbers Receptionvolume
adjustment
Time break recall
Extravolumeand
toneadjustment
Handset cord socket
Clipfor wall
mounting
Redlightoftone/
volumeactivation

5
Description
Battery
compartment
Timebreak
recall
Dialling mode
Pulse/Tone
Handset
cord socket
Memo card
Holesforwall
mounting

6
Description
Volumeandtone
adjustmentON/OFFswitch Line socket
Sendingvolume
setting
Ringvolume
setting

7
1 - Connecting the telephone
- Connect the handset cord.
-Open the batterycompartment.
- Insert 4 alkaline batteries (type AAA 1.5V, not
supplied) in the compartment (*). Batteries are
requiredifyouwishtoincreasetheringerlevelup
to 10 dB.
- Snap the battery door back in place.
-Connectthelinecordplugintothelinesocketon
the rear of the unit (*).
- Connect the other end of the line cord into the
wall PTT socket (*).
2 - Ringer volume setting
Aswitchlocatedontherightsideallowstheringer
to be switched to Hi,Low or Off:
: Off,
: Low,
: Hi
Note: The ring level will be increased of 10 dB if
you insert batteries.
Settingup
(*) Classified TNV-3 according to EN60950 standard.

8
3 - Dialling mode (Tone/Pulse) settings
The Tone/Pulse switch is factory pre-set to Tone
position. In the UK,all telephone exchanges now
use Tone (T) dialing.If your phone does not dial
out,itisprobablybeingusedfromanolderprivate
switch board (PBX).In this case,the Tone/Pulse
switch must be changed to Pulse (P).
4 - Time Break Recall setting (270/100)
YourphoneworkswithatimebreakrecallforUnited
Kingdom(R=100ms).Itcanbeswitchedto270ms
for other locations or PBX’s.
5 - Wall mounting
Towall-mountyourtelephone,turnthe“clip”(located
in the base unit, just below the ear piece).
This will ensure that the handset stays firmly in
position.
Settingup

9
Drill 2 holes in the wall (80mm apart).
Insertthewallplugsandthescrewsleavingabout
6 mm of the screws projecting from the wall.
Slide the telephone downwards to secure.
Settingup
80 mm
1234567
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1234567
6 mm
Screw

10
1 - Receiving volume and tone adjustment
You can increase the volume and adjust the
receiving tone according to your own hearing
requirements.
The button allows extra receiving and tone
functionstobeactivatedornotduringtheconver-
sation.
Whenthefunctionisactivated,theredlightof extra
receivingandtonefunctionlocatednearthebutton
is lit.
Adjust the TONE and VOLUME buttons to fit the
levels to your own hearing requirements.
Volumeandtoneadjustment
VOLUME
0dB
15dB
+30db max
30dB ON
15dB OFF