Geemarc Trimline User manual

Tele
p
hone
USER
GUIDE
GUARANTEE .
From the moment your Geemarc product is purchased,
Geemarc guarantee it for the period of one year. During
this time, all repairs or replacements (at our discretion)
are free of charge. Should you experience a problem
then contact our helpline or visit our website at
www.geemarc.com. The guarantee does not cove
r
accidents, negligence or breakages to any parts. The
product must not be tampered with or taken apart by
anyone who is not an authorised Geemarc
representative. The Geemarc guarantee in no way limits
your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR
GUARANTEE AND MUST BE RETAINED AND
PRODUCED IN THE EVENT OF A WARRANTY CLAIM
Please note: The guarantee applies to the United
Kingdom only.
DECLARATION: Geemarc Telecom SA hereby declares
that this product is in compliance with the essential
requirements and other relevant provisions of the Radio
and Telecommunications Terminal Equipment Directive
1999/5/EEC and in particular article 3 section 1a, 1b and
section 2.
The declaration of conformity may be consulted at www.geemarc.com
Telephone connection : Voltages present on the
telecommunication network are classified TNV-3
(Telecommunication Network Voltage) according to the
EN60950 standard.
RECYCLING DIRECTIVES
The WEEE (Waste Electrical and Electronic Equipment) has been put
in place for the products in end of life are recycled in the best way.
When this product is out of order, please do not put it in your
domestic waste bin. Please use one of the following disposal options:
- Remove the batteries and deposit them in an appropriate WEEE
skip. Deposit the product in a appropriate WEEE skip.
- Or hand the old product to the retailer. If you purchase a new one,
they should accept it .
Thus if you respect these instructions you ensure human health and
environmental protection.
UGTRIMLINE_V1.2
Please read this User Guide carefully in order
to get the very best results from your telephone.

SETTING UP . USING THE TELEPHONE: .
1
–
CONNECTING TELEPHON
E
The plug at the end of the lead should be connected
to the telephone socket.
Voltages present on the telecommunication network
A
re classified TNV-3 (Telecommunication Networ
k
Voltage) according to the EN60950 standard.
2 – RINGER SETTING
The rotary volume control can be used to adjust the
ringer level. Turn anti-clockwise to increase and
clockwise to reduce the ringer volume. Turning to
the extreme clockwise position switches the ringer
OFF.
3 – WALL MOUNTING
To wall-mount
y
our telephone, pull out the clip to the
wall mounting position (located in the
base unit, just below the ear piece).This will ensure
that the handset stays firmly in position. Make 2
holes in the wall 135mm apart, insert the wall plugs
and the wall mounting screws. The
screws should protrude from wall by 10 mm. Place
the phone onto the screw-heads and slide down to
secure.
1
-
ANSWERING INCOMING CALL
S
When an incomin
g
call is received, the telephone will
ring. To answer the call lift the handset and speak.
2- RECEIVER VOLUME SWITCH
The receiver volume switch can be used to
Normal or increase the receiving level to High.
3- MAKING A CALL
Lift the handset, await the dial tone and dial the
required number using the push button keypad. On
completion of the call, carefully replace the handset
in the cradle.
4- LAST NUMBER REDIAL
If the number you have dialled is engaged or if you
want to repeat the call to the number you dialled
previousl
y
, lift the handset, await dial tone and press
the (Redial) button. The previously dialled
number will be AUTOMATICALLY RE-DIALLED.
5- R, * & # BUTTONS
These are used with new services provided on
digital exchanges. For details contact your network
operator.
For product support and help visit our website
at www.geemarc.com
telephone [phone]
or fax [phone]
Receiver
Volume Switch
Ringer Volume
Control