Geemarc PARK LANE User manual

User guide
T e l e p h o n e
Please read this User Guide carefully in order
to get the very best results from your telephone.
GUARANTEE
From the moment your Geemarc product is purchased,
Geemarc guarantee it for the period of one year. During
this time, all repairs or replacements (at our discretion)
are free of charge. Should you experience a problem
then contact our helpline or visit our website at
www.geemarc.com. The guarantee does not cover
accidents, negligence or breakages to any parts. The
product must not be tampered with or taken apart by
anyone who is not an authorised Geemarc
representative. The Geemarc guarantee in no way limits
your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR
GUARANTEE AND MUST BE RETAINED AND
PRODUCED IN THE EVENT OF A WARRANTY CLAIM
Please note: The guarantee applies to the United
Kingdom only.
DECLARATION: Geemarc Telecom SA here by
declares that this product is in compliance with the
essential requirements and other relevant provisions of
the Radio and Telecommunications Terminal
Equipment Directive 1999/5/EEC and in particular
article 3 section 1a, 1b and section 2.
The declaration of conformity may be consulted at
www.geemarc.com
Telephone connection : Voltages present on the
telecommunication network are classified TNV-3
(Telecommunication Network Voltage) according to the
EN60950 standard.
RECYCLING DIRECTIVES
The WEEE (Waste Electrical and Electronic Equipment) has been put in place for the
products in end of life are recycled in the best way.
When this product is out of order, please do not put it in your domestic waste bin.
Please use one of the following disposal options:
- Remove the batteries and deposit them in an appropriate WEEE skip.
Deposit the product in a appropriate WEEE skip.
- Or hand the old product to the retailer. If you purchase a new one, they should
accept it .
Thus if you respect these instructions you ensure human health and environmental
protection.
PARK LANE
UGPLANE_ED02

SETTING UP
1-CONNECTING TELEPHONE
The plug at the end of the lead should be connected
to the telephone socket.
Voltages present on the telecommunication network
are classified TNV-3(Telecommunication Network
Voltage)according to the EN60950 standard.
2-RINGER SETTING
A switch located underside of the base unit allows the
ringer to be switchedONor OFF.
Outgoing calls can still be made when the switch is
set to the OFF position.
3-RECALL TIMING
The switch is set to a RECALL timing of 100 ms which
is used in most countries in the EEC.
If you have any problems with the RECALL function,
please change the switch setting to 300 ms and try
again.
If the problem persists,please contact your network
operator.
USING THE TELEPHONE:
1-ANSWERING INCOMING CALLS
When an incoming call is received,the telephone will
ring.To answer the call lift the handset and speak.
2-MAKING A CALL
Lift the handset,await the dial tone and dial required
number.On completion of the call,carefully replace
the handset in the cradle.
3-LAST NUMBER REDIAL
If the telephone number you have called is engaged or if
you want to repeat the call to the number you dialled
previously,lift the handset,await dial tone and press the
REDIALbutton.The previously dialled number will be
AUTOMATICALLY RE-DIALLED.
4-
These are used with the new services provided on
digital exchanges.For details please contact your
network operator.
For product support and help visit our website
at www.geemarc.com
telephone [phone]
or fax [phone]
RECALL * & # BUTTONS