Genie 36664R Series Use and care manual

Printed in the USA
1. Pull Emergency Release Cord on Carriage to disengage Opener to close door if necessary. (If unable to lower door
using Opener, use extreme caution manually closing door. Before pulling Emergency Release Cord, make certain
people and objects are clear of door opening.)
2. Unplug Opener Power Cord from power receptacle.
3. Open Lens Cover by pressing middle tab inward and remove Light Bulbs. FIG. 1. (See reverse side)
4. Remove Wall Control and Safe-T-Beam wires from Terminal Block located on side of Opener FIG. 2. Use small
common screwdriver to press in on orange tabs while gently pulling wires from block. Mark wires to help facili-
tate replacement.
5. Remove Network and Battery Backup Harnesses from front of Opener (if applicable).
6. Remove the Cotter Pin & Clevis from Door Arm to separate door from Opener. FIG. 3.
7. Remove Motor Head and Rail Assembly from mounting brackets and set on a clean work surface or oor.
NOTE: Be aware of the Motion Detector Bulb on bottom of Powerhead Cover. Do not set operator weight on this bulb
FIG. 4.
8. Pull emergency Release Cord to disconnect Shuttle from Rail (if not already released)
9. Push Shuttle out of Rail towards the door end of the Rail to remove old Shuttle.
10. Install new Shuttle in reverse order.
11. Reinstall Opener Assembly in reverse order as removed. Reference your Owners Manual and Installation Poster.
12. Install Wall Control and Safe-T-Beam wires. Install Battery Backup and/or Network Harnesses if applicable.
13. Install Light Bulbs and close Lens Cover.
14. Install Clevis & Cotter Pins from Door Arms to Shuttle.
15. Remove Release Cord and Handle from old Shuttle and Install on new Shuttle.
16. Move disconnect lever on Shuttle to the upwards position and operate Door until Shuttle connects with Carriage
inside rail. ese two will lock together.
17. Plug Opener in.
18. Clear and reprogram Limit Controls per Owners Manual.
Shuttle Replacement
36664R
37864500887, 02/01/2011
 WARNING
 WARNING
BESUREELECTRICALPOWERHASBEENDISCONNECTEDFROMTHEINPUTPOWERLINESPRIORTOREMOVINGTHE
MOTORCOVER.
!
is repair will require removal of the unit from it’s mounting hardware and repairs made on a bench or oor. Refer to your
Owners Manual and/or Installation Poster for proper assembly and carefully read and understand all warnings and cautions
pertaining to your unit.

ANYANDALLREPAIRSMADETOTHISUNITMUSTBEPERFORMEDWITHTHEDOORDISCONNECTEDFROMTHE
OPENERANDINTHECLOSEDPOSITION.
!

Printed in the USA37864500887, 02/01/2011
FIG.2.
FIG.3.
CLEVIS PIN
COTTER PIN
STB BWC AWC
NOT
USED
NOT
USED
NOT
USED
NOT
USED
FROM STBs
FROM WALL
CONSOLE
Network/
Battery Backup
Ports
Motion Detector
Bulb
FIG.1.
FIG.4.