Genuine Scooter Company Rattler 110 User manual

5400 N. Damen Ave.
Chicago, IL 60625
(877) MY STELLA
www.genuinescooters.com
Rattler 110 Pre-delivery Inspection
(Before Delivery Driver Leaves)
1. Inspect shipping carton for damage
2. Remove top of box and inspect scooter for damage
a. If minor damage has occurred, make driver notate on delivery log, report damage
to Genuine Scooter Co.
b. If major damage has occurred, refuse shipment, report damage to Genuine
Scooter Co.
(Setup and Prep)
1. Open seat and find the following items
a. Right and left mirrors
b. Battery
c. Rear fender extension
d. Rear reflector
e. Battery cover
f. Bag of screws
g. Owners manual
2. Remove battery from box
a. Remove plastic cover from acid cartridge
b. Remove foil from top of battery
c. Insert cartridge firmly into top of battery
d. Let cartridge drain fully into battery
e. Charge battery at 2 amp for 2 hours
f. After charging re-install plastic battery cover
g. Install battery in battery holder in scooter floor board (Fig. A)
h. Connect red wire to positive side of battery
i. Connect black wire to negative side of battery
j. Install battery door and secure with screw
3. Fill two stroke oil tank with high grade two-stroke oil
(reservoir is located above floorboard, under front edge of seat) (Fig. B)
4. Fill gas tank
5. Add one ounce of two-stroke oil to the first tank of fuel
6. Check gear box oil
a. Remove white plastic plug
(plug is located on engine case to the left of the rear wheel) (Fig. C)
b. Spin rear wheel in forward motion

c. As wheel spins, look at internal gears for oil
d. If no oil is present fill with 110 cc of SAE 140 oil
e. If refilling fill with 90cc of SAE 140 oil
7. Adjust rear brake (using cable tension adjuster on rear drum)
8. Check front brake for firmness
a. While pulling and holding front brake inspect lines and caliper for seepage
9. Install mirrors
a. Blue bag for right (note: right mirror is left hand thread)
b. Yellow bag for left (note: left mirror is right hand thread)
10. Install mud flap and rear reflector
11. Check tire pressure (30psi front and rear)
12. Remove all protective packing materials, seat cover, and plastic film from reflectors
(Starting and Break-in)
1. Make sure key is in the run position
2. Make sure kill switch is in the run position
3. Crank engine in five second sessions to prime engine
4. Start engine
5. While engine is running listen for unusual noises and rattles
6. Visually inspect for fuel and or oil leaks
7. Check for loose bolts and nuts
8. Check high and low beam operation
9. Check turn signals for proper operation
10. Check tail and stop lamp operation
11. Test drive
REMEMBER, THIS IS A 2-STROKE SCOOTER AND IT NEEDS A SOFT BREAK-IN PERIOD.
BIKE SHOULD NOT BE DRIVEN OVER 50 MPH FOR THE FIRST 500 MILES.

Fig. A
Battery holder location.
Fig. B
Fig. C
Look into hole to view gears.

Rattler 110 Troubleshooting Guide.