GGM gastro SPEWHA3 User manual

1
Ice-cream Cart
PLEASE READ THE OPERATION MANUAL BEFORE USING.
SAVE THIS MANUAL FOR LATER USE.

2
CONTENTS
content
2
Parts and Features
3
Gelato Cart(Showcase) Safety
4-6
Transportation and installation instructions
7
Operating Your Showcase
7-8
Care and Maintenance
9
Technical data and problems
10

3
PARTS & FEATURES
SPEWHA3
SPEWF6

4
SHOWCASE SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read
and obey all safety messages.
This is the Safety Alert Symbol. This symbol alerts you to potential hazards that
can kill or injure you and others. All safety messages will follow the Safety
Alert Symbol and either the wards”DANGER”, “WARNING”or “CAUTION”.
Danger means that failure to heed this safety
statement may result in severe personal injury
or death.
Warning means that failure to heed this safety
statement may result in extensive product
damage, serious personal injury, or death.
Caution means that failure to heed this safety
statement may result in minor or moderate
personal injury, or property or equipment
damage.
All safety messages will alert you to what the potential hazard is, tell you how to reduce the chance of
injury, and let you know what can happen if the instructions are not followed.

5
IMPORTANT SAFEGUARDS
Before the chest showcase is used, it must be properly positioned and installed as
described in this manual, so read the manual carefully. To reduce the risk of fire,
electrical shock or injury when using the chest showcase, follow basic precautions,
including the following:
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety
Children should be supervised to ensure that they do not play with the appliance.
DANGER or WARNING: Risk of child entrapment: Child entrapment and
suffocation are not problems of the past. Junked or abandoned showcases are still
dangerous, even if they will “just sit in the garage a few days.”
Before you throw away your old showcase: Take off the doors. Leave the
shelves in place so that children may not easily climb inside.
Please according to local regulation disposal of the appliance for its flammable
refrigerant and blowing gas.
The showcase must use the separate pin outlet to be connected with earth correctly,
never with the heating pipe and coal gas pipe.
The showcase shall be positioned so that the plug is accessible.
If the supply cord is damaged, the manufacturer of its service agent or a similarly
qualified person must replace it in order to avoid a hazard.
Do not attempt to repair or replace any part of your chest showcase unless it is
specifically recommended in this material. All other servicing should be referred to a
qualified technician.

6
The showcase should not be located next to ovens, grills or other sources of high
heat.
Keep ventilation openings, in the appliance enclosure or in the built-in structure,
clear of obstruction
Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer
Do not damage the refrigerant circuit
Do not use electrical appliances inside the food storage compartments of the
appliance, unless they are of the type recommended by the manufacturer
Before proceeding with cleaning and maintenance operations, make sure the power
line of the unit is disconnected.
Do not connect or disconnect the electric plug when your hands are wet
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other showcase. Never clean showcase parts with flammable fluids.
The fumes can create a fire hazard or explosion.
If the voltage is unstable, please choose the suitable automatic voltage regulator
Connection the power to check the showcase before using, the showcase can be
used until the temperature decreases obviously after 30 minutes
You should adjust the temperature control according to the requested temperature
and quantity of the stored food and the environmental temperature.
Before putting the stuff into the showcase please adjust the temperature control to
the lowest point and let it work till the temperature of inner cabinet decreases to -
18℃and then putting the stuff in, after 12 hours adjust the temperature control to the
normal point.
Never put hot food in the showcase directly only after it has been cooled naturally
outside
The stuff should be put into the showcase partially, each lot will not be more than
the figure which is equal to the capacity(L) divide by 20
Not full the showcase and make it crowded, big meat should be divided into several
small parts. There should be reasonable space between the foods for better freezing
If power cut off is needed, you should wait for at least 5 minutes before turn on
again to avoid damage to the compressor.
The stuff stored should be packed with plastic bag well to avoid smell-mixed and
moisture-lost, and reduce the frost at the small time
Beer, beverage, fresh flower, medicine and injections can not be put into the
showcase
Please make the temperature control to the lowest point if you want to store ice
cream or other uneasy-frozen food
We have a policy of continuous improvement on our products and reserve the right
to change materials and specifications without notice. To confirm the specific
parameters, please accord to the rated label on the product
Shall, when the product scrap/recovered by professional scrap/recycling locations to
deal with.
This product application environment temperature up to 32℃.

7
TRANSPORTATION AND INSTALLATIONN INSTRUCTIONS
1. When you transport the showcase, the angle between the
compartment body and the ground should be no more than
45°and you should never place the showcase up-side down.
2. Do not use any of the external part as loading points, for
example, the condenser on the back, the door.
3. When the showcase is installed or used, all the package
(including board and foam plastic) should be got rid of.
4. Keeping the showcase stable to avoid vibration and noise.
5. The showcase should be installed in the place with good ventilation, a space of at
least 10cm should be allowed between the surrounding walls and the cabinet wall for
air condition.
6. It should be placed far from heating resource and not under direct sunshine to avoid
decrease of the efficiency of refrigeration.
7. Install the showcase in a dry place so as to prevent rust on the compartment body,
which may affect the electric insulation.
OPERATING YOUR SHOWCASE
THE FUNCTION OF CONTROL PANEL:
There are totally 3 button.
1．button (SET)
In normal,press more than 3 seconds,will be enter the parameter menu.
In this process,the parameter name and parameter are displayed alternately when you
press button.If press button more than 3 seconds,will save the setting.
Press "SET" and " ",defaults will be restored,show "CF".
2. button
In parameter menu,press this button can move to next one, or increase the parameter
value.
3. button
In parameter menu,press this button can return to previous one, or reduce the
parameter value.
Press more than 3 seconds,It can enter or exit the defrosting state.（If D1=0,Unable to
enter the defrosting state)

8
STORAGE：
1. The appliance is suitable for storing ice cream and ready-frozen foods.
2.It must not be filled higher than the stacking mark on the inside of the showcase.
3. If there is no load line sticker,please take the top of placed basket as standard.
LOAD LINE
DEFROST:
1. Defrost when the frost thickness on the wall of the cabinet reaches 5mm to optimize
the freezing capacity.
2. Turn the temperature control to the lowest point for 5-6 hours before defrosting.
3. Cut off the power and take out the food, use the defrost removal, do not apply sharp
tools.
4. After defrosting, clean the wall with dry cloth, and then power on.
THE FOLLOWING PHENOMENA ARE NORMAL:
1. There will be sound of flowing water when the refrigerant is running.
2. The frozen food do not melt even if a long time power off.
3. When the environment humidity is too high, there will be dew condensed on the
surface of the showcase.
4. When the machine is running, the condenser and compressor will be hot.

9
CARE AND MAINTENANCE
MAINTENANCE AND CLEANNESS:
1. Do not open the door frequently and too long to save energy.
2. Never leave heavy or hot stuff on the top of the showcase to avoid deforming.
3. Cut off the power before cleaning.
4. To clean the showcase, please use soft cloth dampened in some moderate
detergent and hot water.
5. Use warm water to clean oil or fruit juice stain on the magnetic gasket in order to
keep its elasticity. Apply some talcum powder to it to prolong its service life.
6. The showcase should not be left unused for a long time, to stop using the
showcase, disconnect the main power first, then clean the inside and leave the door
open for 2~3 days to dry it.
Correct Disposal of this product
This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take this
product for environmental safe recycling.

10
TECHNICAL DATA and PROBLEMS
TECHNICAL DATA:
Model
Effective
Volume
（L）
Climate
Class
Net
Weight
(kg)
Overall
Dimension (mm)
Power
Refrigerant
SPEWHA3
256
N
145
1570*862*2276
220~240v/50Hz
R290/90g
SPEWF6
256
N
126
2665*950*2600
220~240v/50Hz
R290/90g
TROUBLE SHOOTING:
TROUBL
ES
REASON
SOLUTION
Unfreezing
*Temperature control is on the
highest point
Adjust the temperature
*Plug and outlet not connected well
Make they two connect well
*Fuse broken off
Change the fuse
Compresso
r can not
stop
working
*Temperature control is on the lowest
point
Adjust temperature control
*Too much stuff stored in one time
Reduce the quantity
*Thick frost
Defrost
*Too much times of door-opening
Reduce the times of door-opening
*Too near the wall
Far from the wall
*Near the hot source or sun
Change the place
Big noise
*Ground is not flat
Change the place
*Refrigerating tubes connected
Separate them
REMARK: If you can not solve the troubles according to the above-mentioned ways, please contact
the after-sale service, do not handle it yourself.