GMI CBL-120-12 Series User manual

CBL-120-12 Series Work Bench
TOOLS REQUIRED FOR ASSEMBLY
Socket set, Open end wrench set, Cordless drill with
3/8" socket bit (Magnetic recommended).
BEFORE ASSEMBLING THE WORKBENCH
Assembly of this bench will require 2 people.
Read through the assembly instructions to
familiarize yourself with the order in which the
parts are assembled. We suggest that you clear
& vacuum the area where the bench is to be
assembled. It is important that the bench is
assembled in the same sequence as instructed.
HARDWARE
All assembly hardware is provided.
1/4-20 x 1/2”
Flange Head Bolt
STEP 1
Nylock Nut
3/8- x 1/2”
Hex Head Bolt
**Units are difficult to move once assembled.
Begin assembly near the bench's final location**
Begin by assembling three of the base cabinets together on one of the two riser sections. Set the riser on the floor and
position three of the base cabinets on top of the riser.
The cabinets will bolt to each other using (8) 3/8 x 1/2” hex head bolts and nylock nuts. Finger tighten the three
cabinets together at first. Once finished position the cabinets on the riser so the holes in the bottom of the cabinets
line up with the pre-installed nuts on the riser base. Attach to the riser using (12) 1/4-20 x 1/2” Flange head bolts. Now
tighten all bolts.
Repeat these steps for the remaining section of three cabinets and riser section. Once assembled, position the two
halves together and bolt both halves together using (4) 3/8 x 1/2” hex head bolts and nylock nuts.
Pre-Installed Threaded
Nuts

STEP 2
Place the top on the row of cabinets. Center the top
left-to-right. Adjust top to desired location
front-to-back.
Attach using (4) #14 x 1" Lag Screws per cabinet.