8
Turntable Mode
AUX-IN Play Mode
1. Turn on the unit power
2. Select Aux-in mode using the mode select button
3. Connect your chosen device to the unit’s aux-in jack using
the cable provided
4. Press the play/pause button to begin playback
5. Use the volume controls to set the desired sound levels
The Ambassador’s Bluetooth mode allows you to stream your vinyl
to any Bluetooth enabled speaker or headphones.
1. Turn on the unit power
2. Select Bluetooth mode by holding the mode button down for
3. The Bluetooth indicator light will flash rapidly as the unit
4. When paired the blue light will flash shortly with a three
5. If the devices fail to sync, please repeat points 1-4.
6. Use the volume controls to set the desired sound levels
7. Hold down the stop button for three seconds to turn off
Please note:
speaker or headphones, please ensure that the device you wish to
stream vinyl to is set to pairing mode. This will allow them to sync.
1. Press the mode button until the red LED light next to
2. Insert a blank USB stick into the slot
3. Place the desired vinyl onto the turntabled and begin playing.
4. Press the record button on the control panel, the red light
GPO_Ambassador_EU_Manual_V3_Jan 2018.indd 8 17/12/2017 22:41
Turntable Mode
1. Turn on the unit power
2. Select Turntable mode using the mode select button
padaMPR54ehtgnisu,gnittesdeepstcerrocehtesoohC.3
needed, and place the vinyl record onto the turntable
4. Place the tone arm into the correct position to begin playback
5. The turntable will stop automatically when the recording
has finished.
6. Use the volume controls to set the desired sound levels
AUX-IN Play Mode
1. Turn on the unit power
2. Select Aux-in mode using the mode select button
3. Connect your chosen device to the unit’s aux-in jack using
the cable provided
4. Press the play/pause button to begin playback
5. Use the volume controls to set the desired sound levels
USB Play Mode
1. Turn on the unit power
2. Select USB mode using the mode select button
3. Connect your USB device to the unit using the USB slot
4. Press the play/pause button to begin playback
5. Use the volume controls to set the desired sound levels
6. To record from vinyl to your device, select USB record mode
7. Press record to begin recording
8. Press stop to cancel recording
1.Connect the small DC jack into the DC-IN port on the rear of
the unit.
2. Connect the plug to a mains outlet and turn the power
socket on.
3. Turn on the unit using the Power/Volume Control.
4. Use the mode select button until the LED indicator shows
that you have selected turntable mode:
5. Place your chosen vinyl record onto the turntable.
6. Set the correct speed (RPM) of your record using the RPM
Speed Control.
7. Move the tone arm to the desired starting point on the
record. The turntable will now start to play.
8. Auto-stop on, the turntable will start spinning when the arm
is moved towards the record, when the last track is finished
the turntable will stop spinning.
9. Adjust the volume to your preferred volume.
10. Auto-stop off, the turntable will start spinning as soon the
record play function is selected, when the last track is
finished the turntable will continue to spin until the unit is
switched off or until a different mode is selected, this
function is only required for certain 45 rpm records that are
pressed more towards the centre of the record.
