Grandview CN-MRxx User manual

Instruction Manual for
CNV series Motorized Screen with IR Remote Control

Attention:
> Please make sure there isno dust or dirt on thefabric surface before rolling it backto the casing
> The recommened working time is less than 50 seconds. The motor will enter overheating protection
status and stop working for everycontinuous 4 minuters operation, user wouldneed to wait for a
while until the motor cool downbefore operating again.
> There is no lube needed for the motor. Please be noticed that the appropriate setting is optimized which
requires no further adjustment, please consultthe after sales team before adjustingthe limits.

How to install the battery:
1.Turn the controller around,push to open the cover asguide arrow.
2.Put the battery in accordingthe guide of cathode and anode.
3.Close the cover.
UP
DOWN
STOP
LED
remote controller
Controller button instruction
1.To raise screen press "UP .
2.To hold screen at desired position press STOP .
3.To lower screen press DOWN .
1.
2 will
3 will if
4
5
6
7
"
""
""
Caution:
The shortest distance between receiver and controller is 0.5 meter.
.Controller work within 30 degree away horizontally from the cen ter of recei ver
point within 8 meters from the screen.
.The controller not work the signal was coveredby something.
.Keep the controller far away from high temperature and humid situation.
.Please change the battery when the signal is weak.
.Please take the battery out if the controller was not being used for long time.
.Please choose the same type battery as original supplied.
4. To raise the screen little at your desired position press MICRO-UP
5. To lower the screen little at your desired position press MICRO-DOWN
1GD¡ªIRan
MICRO-UP MICRO-DOWN
Instructions