Green Bike USA GB5 User manual

Green Bike USA
6601 Lyons RD
Suite G7
Coconut Creek, FL 33073
Tel: [phone]
Email: [e-mail]
GB5/GB500/GB500 FAT TIRE MANUAL

Congratulations on your new electric bike.
Welcome to Green Bike USA family.
Up to now electric bikes have been far too expensive, Green Bike USA electric bikes has changed
that. Now everyone can afford to own an electric bike, no license, registration or insurance required.
Electric bike is fun, safe, easy to use, green and now it’s also affordable. Green Bike is a USA company
based in Florida. We committed to provide our customers the highest quality products, world class
service and good prices.
We will send your bike by UPS or FedEx in a box as shown below, from one of our warehouses in
the US. If your box came damaged, please take pictures on your phone and let us know right away.
Assembly
Open the box carefully, take out the bike, the seat and a small carton box. In the small box you have
the charger and few tools (you don’t need any tools to assemble the bike).
1. Remove all the protection material.
2. Insert the handle bar (A) into it’s rod (B) (the rod need to be folded in order to do it) all the way
in (you can adjust after). Lock it by turning the lock (C)
A
C
B

3. Bring the rod (B) to straight position and lift the quick release handle (D) to lock the
handle bar. The loop in the quick release handle must be secured by the black round clip
(E). To fold the handle bar you just need to reverse this steps.
Final Position
E
D

4. Unfold the bike to a straight position than lock the metal bar (F) than turn down the plastic lock
(G) to secure the metal bar.
To fold the bike, you just need to reverse this steps.
5. Unfold the pedals. You can easily fold them when you want to store the bike or put them in your
trunk. Just press here to fold and unfold and push the pedal up or down.
CLOSE
OPEN
F
G

6. Insert the seat into the seat bar, make sure it's inserted to at least the minimum length (H),
which is marked on the seat bar. Make sure that the seat is tight and at the right height for you.
7. Open the lock (J) to adjust the angel of the handle bar, so you can comfortably use the brakes
and look at the display.
H
J

Disc Brakes
Disc brakes are considered to perform better than standard v-brakes, especially in wet
conditions, our new GB500 model comes with front and rear disc brakes. Please note that brand new
disc brakes need “braking in”. This means it may take a few weeks until they perform optimally. Ride
your bike very carefully and allow plenty of time for braking.
Battery
Make sure that the round metal pin (K) of the battery lock needs to be aligned correctly with the
round opening in the metal bar. Push the battery down or lift the battery up to align the bolt with the
opening. If it’s not aligned correctly, the bolt will hit the silver metal bar and you will not be able to turn
the key.
K

UNLOCK - battery can be removed. You can charge the battery also when it’s not connecting to the
bike (push in and turn all the way counterclockwise).
OFF - battery locked into the frame. Power is off.
ON - battery locked into the frame (turn all the way clockwise). You can turn on the bike.
Only at OFF position you can take out the key from the battery.
Attention: always turn the key gently, if you are using force, you are doing something wrong and you
can break the key.
Removing the battery is super easy, you just need to push up the battery quick release (L) to fold the
seat. Now you can take out the battery (key is in UNLOCK position).
ON
OFF
L

Charging the Battery
Green Bike USA Electric Bikes are equipped with quality
Lithium batteries. Lithium batteries are a modern technology
which is not suffering from memory effects like some older
battery types, which means that Lithium batteries can be
charged anytime, this will not reduce the battery life. To charge
the battery, move the Cover (M) gently to the side, connect the
charger to a power point and then connect the charger to the
battery. The chargers are smart chargers, which means they will
automatically stop charging when the battery is full. The charger
has light indicator. If it’s RED, it means it’s charging the battery.
If it’s GREEN, it means the battery is fully charged.
The battery takes about 3 hours to charge if it’s completely
discharged. If it’s not fully discharge, it will take less time to
charge. It is recommended to switch the battery OFF while
charging.
Checking the Battery
In order to check the battery charge, you need to switch the battery to ON with the key.
once the battery is switched ON, there are two ways to check the battery charge: hold down your
finger on the white button on top of the battery (the battery doesn't need to be in the bike). If the
battery is fully charged, there will be two green lights and one red light on the battery display (N)
(on top of the battery). If the battery not fully charged, there will be only one green light. If you
see only the red light, then you need to charge your battery.
M
N

Another way to check how much power left in the battery is by turning on the LCD display (battery
assembled and turned ON) by pressing on Mode (O), the battery picture (P) will indicate how much
you have left (don't use the throttle when you check your battery, if you do it will not give you the right
reading).
Battery Care & Storage
Lithium batteries should not be stored if fully discharged. If your battery is fully discharged, charge
it as soon as possible. Storing the battery if fully discharged for long periods will damage the battery. It
is recommended to store the batteries fully charged and then charge it every two months. Do not leave
the charger connected to the battery if stored for long periods.
O
P

Throttle
Twist and go throttle (Q). Twist down to accelerate, release to stop acceleration.
Motor Assistance
There are 9 levels of motor assistance. Press + or - to change motor output power. The power
ranges from level 1 to level 9. Level 1 is the minimum power and level 9 is the maximum power. If you
put it on 0 you can use the bike as regular bike without the electric motor, however if you push down
the throttle you will get power from the electric engine, the more you push the more power you get.
Q
Levels controller

Derailleur
Follow below link for an excellent YouTube video about rear derailleur
adjustment http://www.youtube.com/watch?v=wQncKmddahk
You can use the Shimano regular 6 levels gear anytime you ride the bike. You can control the
effort that you want to put by choosing the motor assist level that you want.
Lights, Right and Left signal, Brakes Light & Electric Horn
To turn on and off the front and back lights press the red button (R) with your left hand. To use
the left and right signals use the black button (S) when you signal there will be also a beeping noise.
Brake light (T) will show when you press one of your brakes. To use the electric horn, press the green
button (U).
Dow
n
U
p
R
S
U
T

LCD Display
Function summery:
1. ON/OFF
2. Full view area
3. Riding mode
4. Distance display
5. Riding time
6. Battery indicator
7. Speed indicator
8. PAS level
3.5’ big screen for easy view
Phone USB charging port
Easy buttons, easy control
Water prove
LED light

9. Error instruction
10. 6KM push button
11. Button operation
12. Auto sleep after 5mins
13. Mobile phone charging indicator
1. ON/OFF
Press ON/OFF and start the display. With display on more than 3 seconds, press ON/OFF to turn off
power supply of the e-bicycle.
2. Full View Area
3. Riding Mode
We suggest to leave it in normal. ECO is a power saving mode.
Power
Normal
eco
4. Distance display
Press SET to switch the display information:
ODO - total distance
TRIP –one trip distance

5. Riding time
A single riding time will shut down without saving
6. Battery indicator
7. Speed indicator
8. PAS level (pedal assist)
Press +/- to change the PAS level. The higher the level, the more power you get from the motor. To
get the power from the motor you just need to pedal, to use the throttle or do both. At level 0 when
you pedal the bike will not get power from the motor. However, if you use the throttle you will get
power from the motor.
9. Error instruction
It will show error code when system has problem. The following is the error code instruction:
(1) current error
(2) throttle error
(3) motor no phase position
(4) Hall error
(5) Brake error
(6) communication display receiving error
10. 6KM push button
Keep press DOWN button for 2 seconds, it will get in 6KM walking condition. You can use this if you
want to get a little power while walking with the bike.

11. Button Operation
Once the display is ON press it again to turn on’/off display light.
Press the SET for 3 seconds to get to setting mode.
Set 0: press +/- to change the riding mode
Set 1: press ‘-‘the TRIP go back to 0
Set 2: Setting speed limit 11.2 MPH to 31.2 MPH (set to 31.2 MPH for the most power from the bike)
Set 3: for setting wheel size, make sure it’s on 20 in.
Set 4: for setting Km/Mile
Set 5: no need to touch
Set 6: for setting the 36V/48V of system voltage (make sure you are on 48)
Press +/- to select parameter, hold SET for 1s to save and exit.
12. 5 min auto sleep
The system will turn off automatically after 5 min. when not using the bike.
13. Mobile phone charging indicator
Press + and SET for 2s to turn on the USB charging indicator. It has to be on in order to be able to
charge the phone.
USB

64 inch
Display Warranty
Warranty term is 18 months.
Beyond warranty:
1. Opened display
2. Connector gets damaged
3. Damage on housing after delivery.
4. Wires gets scratched or broken
5. Irresistible accident such as fire or any other natural hazard.
6. Over 18 months.
Servicing the Bike
Very important to check your tires pressure once a week, we recommend 50 psi.
Also you need to keep the bike lubricant specially if you are going to leave them outside.
For optimal performance, it is recommended to have the bike serviced by your
local bike shop after assembling it to make sure it's safe to ride.
It is recommended to service the bike regularly like a regular bike every 1000
Mile or at least once a year and have the spokes adjusted at each service. The electric
parts don't need to be serviced, therefore servicing can be done at a regular bike
shop.
Weight & Dimensions
33 inch

Weight: 59 Lbs
Minimum chair height from the floor: 33 inch (look at pg 4 as for minimum
length of the chair bar that need to be in the frame).
Maximum height from the floor 36.5 inch.