Greenbroz 215 CannaGin Destemmer User manual

Shroud
Faceplate

1. Faceplate*
2. Shearing Door (x2): Gently assists in the removal of flower from the stem.
3. Shroud Knob: Tightens and fastens the shroud to the CannaGin body.
4. Shroud: Prevents user exposure to the rollers and guides stem removal.
5. Emergency Stop Switch: Instantly stops the CannaGin.
6. Digital Display: Displays revolutions per minute (rpm).
77. Forward / Reverse Switch: Changes the direction of the motor.
8. Speed Dial: Adjusts the rotation speed from 1-80 rpm.
9. Operation Switch: Go between standby and run. The motor will rotate when switched to run.
10. Stem Guide (x7): Feed branches from the base of the stem into one of the guides.
11. Ramp: Gently guides your flowers into a container after being destemmed.
12. Power Outlet & Master On / Off Switch: Controls power to the 215 CannaGin.
13. Rollers: Will pull stems through for the destemming action to occur.
*
*
The 215 CannaGin comes with the faceplate shown in the image above (2 shearing doors and 7 total stems guides).
We sell an alternative faceplate that comes with 4 shearing doors and 4 total stem guides. Please contact your local
GreenBroz Sales Manager or reach out through the information below for more information.

Please note the following recommendations before operating the machine:
Tolerance for the machine is based on density of the product. Different strains with
different moisture content will require RPM and door pressure adjustments.
For best results, use branches that are 1 foot in length, or longer.
Remove the top kola from your branch (optional).
Feed branches from the base of the stem to the top.
TIP: You may switch direction to “reverse” to free up any tangled stems. When
switching diswitching directions the same RPM will be applied.
While the GreenBroz CannaGin can be used on either fresh and turgid
flowers or dried flowers, when using the CannaGin as part of the
GreenBroz Inc. dry-trimming process, we recommend that flower
moisture levels match the recommended levels of our dry trimmers.
Product Preparation & Processing Recommendations

Note: To reset the emergency stop button after it’s been engaged, simply press down
and rotate counter-clockwise until the button releases back into the set position.
1. Check to make sure the main power outlet switch is in the “off” position.
2. Make sure the operation switch is in the “standby” mode.
3. Plug in the power cord.
4. Turn main power switch “on”.
5. The controller should be illuminated and read 0.0.
6. Place the forward/reverse switch to the “forward” position. Turn the dial.
77. Switch the controller to the “run”mode and the machine will start rotating.
8. Adjust the dial to change the revolutions per minute.
9. Lift a shearing door and feed a branch into the stem guide.
We recommend reviewing all of the disclosures and following all of
the instructions to ensure optimal processing. Prior to use, ensure that machine placement
is sound to prevent the machine from moving during operaiton.
Machine Operation & Troubleshooting

Product Registration
Limited Warranty Information

215 CannaGin Destemmer
215 Dry Trimmer
Model M Dry Trimmer
215 420
215 / 420 Alchemist Trichome
Extractor
Rise Conveyor
The Precision Batcher
Sorter
844.DRY.TRIM | [e-mail] | greenbroz.com
Laser Counter
More GreenBroz Harvesting Tools