Grundig HYDROS SR 9100 PLL User manual

SHOWER RADIO
ǵ
HYDROS
SR 9100 PLL

ENGLISH
9
Packing contents
1Shower Radio
2Stand
3Wall holder with screws for wall mounting
4Suction cup for the antenna
5Operating manual
6Guarantee information
Safety instructions
•To ensure that this device provides you with long-term satisfaction and
enjoyment, please observe the following instructions.
•This device is designed for the playback of audio signals. Any other use is
expressly prohibited.
•Do not drop the device into the water or subject it to continuous contact
with water. Avoid using it for long periods in the rain or damp.
•Protect the device from excessive heat (do not place it on the heater, for
example).
•Only use a soft duster to clean the housing. Do not use abrasive cleaning
or polishing agents.
•Never open the device casing. The manufacturer accepts no liability for
damage resulting from improper handling.
•The type plate is located on the back of the device.
Technical data
Power supply
Batteries: 3 x 1.5V batteries (type LR06, AM3, size AA)
Frequencies
Frequency band: FM (VHF) 87.5 – 108.0 MHz
The device is noise-suppressed according to the applicable EU directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regulation VDE 0860 and therefore the
international safety regulation IEC 65.
Technical and optical modifications reserved.
SHOWER RADIO___________________
ENGLISH

10
Inserting the batteries
1Dry off the device if necessary.
2Open the battery compartment on the back of the device.
3Insert three batteries (type LR06, AM3, size AA 1.5 V). Note the polari-
ty marked on the bottom of the compartment.
Note:
If the device receives no power for longer than 1 minute after the used
batteries are taken out, the time and any preset stations are deleted.
Before you can use the device again you may have to press the
»RESET« button on the bottom of the battery compartment (below the
middle battery).
4Close the battery compartment.
Note:
When you close the battery compartment, make sure the lid is properly
fitted and watertight.
We recommend alkaline batteries for a prolonged lifetime. Do not mix
batteries of different types.
You must remove the batteries if they are flat or have not been used for a
long time. No liability is accepted for damage resulting from leaking
batteries.
Batteries, including those which are heavy metal-free, may not be dis-
posed of with household waste. Please dispose of used batteries in an
environmentally sound manner. Find out about the legal regulations
which apply in your area.
POWER SUPPLY ___________________

ENGLISH
11
Controls
ON/OFF Switches the radio on and off;
switches the timer off
FWD/HR Tunes the radio frequency; sets the
hours; changes between 12 and
24 hour clock if you press »REV/
MIN« at the same time
REV/MIN Tunes the radio frequency; sets the
minutes; changes between 12 and
24 hour clock if you press »FWD/
HR« at the same time
TIME SET Sets the time if you press
»FWD/HR« or »REV/MIN« at
the same time
STATION Buttons for 4 preset stations;
1 ... 4 hold down (2 sec.) to store a station
+VOLUME - Increases the volume; reduces the
volume
TIMER Sets the timer; displays the time set
for the timer for 5 seconds
Opening on the back of the device
for attaching it to the wall holder
Display
Preset station 1 is selected (4 presets)
103.8 Frequency display (103.80 MHz)
103.8. Frequency display (103.85 MHz);
the second decimal place displayed
after the decimal point ».« on the
right is always 5.
MHz Frequency display
FM Frequency band
20:38 Time display in 24 hour format
8.38 Time display in 12 hour format
PM Time display in 12 hour format is
selected
ȄTimer function is activated
OVERVIEW ________________________
1
1234
88
88:
.
.
MHz
PM
FM
Ȅ

12
Clock operation
When you insert the batteries into the device for the first time, the time
flashes in the display to indicate that you must set the clock.
Setting the clock
1Press and hold down »TIME SET«.
2Press »FWD/HR« to set the hours and »REV/MIN« to set the minutes.
3Press »FWD/HR« or »REV/MIN« once to move forwards in steps of
one hour or one minute.
Note:
If you hold the buttons down longer than 0.5 seconds, the time increases
continuously.
Switching between 12 and 24 hour format
In the 12 hour format the time displays in the morning and the afternoon are
identical. The abbreviations AM and PM are therefore used to differentiate
between the morning and the afternoon. If you select 12 hour format »PM«
appears in the display after noon. There is no additional identification in the
morning.
1Press »ON/OFF« to switch off the device.
– The time appears in the display.
2Press »FWD/HR« and »REV/MIN« at the same time and hold them
down for 2 seconds.
– The time shown in the display changes between 12 and 24 hour for-
mat.
3To change the format again repeat step 2.
Time display
During radio operation you can select permanent time display or frequency
display.
1Press »ON/OFF« to switch on the device.
– The frequency of the station you were last listening to appears in the
display. After a short time the set time appears continuously.
2Press »TIME SET«.
– The current frequency is displayed continuously.
3Press »TIME SET« again.
– The display changes and the set time is displayed continuously.
Note:
If you press »STATION 1 ... 4«, »FWD/HR« or »REV/MIN« while
the time is displayed, the current frequency briefly appears.
OPERATION _______________________
30
28
:
29
15
:
38 8
:
PM
2
78 5
.
MHz
FM

ENGLISH
13
20
Ȅ
Switching on/off
1Press »ON/OFF« to switch the device on and off.
Radio operation
Station selection
There are several ways to select the station with the device:
1Briefly press »FWD/HR« or »REV/MIN« to set the frequency manual-
ly.
– The frequency changes in 50 kHz steps (CE version) or 100 kHz steps
(FCC version).
or
Press and hold down »FWD/HR« or »REV/MIN« then let go.
– The automatic station search begins and then stops at the next station
it finds.
or
Select a preset station by pressing »STATION 1 ... 4«.
Storing stations
1Tune to the station you want to store.
2Press and hold down one of the station buttons »STATION 1 ... 4«.
– The signal tone indicates that the station has been stored on the but-
ton.
3To store more stations on the other buttons repeat steps 1to 2.
Timer settings
If the timer function is selected, the device switches off after the set time.
1Activate the function by pressing »TIMER«.
– The device switches itself on and the minimum time you can set
(5 min.) appears for 5 seconds in the display.
2To select the time, keep pressing »TIMER«.
– The device switches itself off after the set time has elapsed.
Note:
The timer can be set to 5, 10, 15, 20, 30 or 60 minutes. 5 seconds after
you finish the setting the clock or current frequency is displayed again.
To check how much time is left on the timer, press »TIMER« once. To
switch off before the set time, press »ON/OFF«.
OPERATION __________________________
30
18
.
MHz
FM
2
30
18
.
MHz
FM

Grundig AG •Beuthener Str. 41 • D-90471 Nürnberg • http://www.grundig.com 72011-400.8500