Guardian Fall Protection 10733 User manual

Trauma Strap
Part #:10733
Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
PRIOR TO USE, READ AND UNDERSTAND ALL
INSTRUCTIONS INCLUDED WITH EQUIPMENT
AT TIME OF SHIPMENT.
INSPECTION:
MAINTENANCE:
Cleaning after use is important for maintaining the safety and longevity of the Trauma Strap. Remove
all dirt, corrosives, and contaminants from Trauma Strap before and after each use. If Trauma Strap
cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. To fully dry,
unravel the contents and hang them to dry. NEVER clean Trauma Strap with corrosive substances.
When not in use, store equipment where it will not be affected by heat, light, excessive moisture,
chemicals, or other degrading elements.
Prior to each use, inspect Trauma Strap for any frays, cuts, broken fibers, burns, discoloration, knots,
tears, abrasions, cracking, rust, and any other damage. If any of these conditions exist, IMMEDIATELY
remove Trauma Strap from service. Competent Person must inspect at least every 6 months.
Maximum worker capacity: 420 lbs.
Materials: nylon, polyester, and steel.
The Trauma Strap is not intended to
replace a rescue plan. The employer
must always have a jobsite-specific
rescue plan in place, and the means to
implement that plan.
Misuse or alteration to this product
may result in SERIOUS INJURY OR DEATH!
Seek medical attention immediately
if exposed to a fall/suspension.
The Trauma Strap is not to be used as
an anchor, lanyard, or any other form
of fall protection, except in the manner
detailed by these instructions.

Guardian Fall Protection 6305 S. 231st St., Kent, WA 98032 phone: [phone] fax: [phone] www.guardianfall.com
ATTACHMENT:
USE:
Install Trauma Strap immediately
above where leg straps meet
side/shoulder straps (as shown).
5. Trauma Strap is now installed
and ready to use.
4. Repeat steps 1-3 on second side.
3. Secure Trauma Strap snap buckle
around harness strap.
2. Pull Trauma Strap pouch through
web loop and choke down to
harness strap. Pouch must be on
outside of harness strap
1. Pass Trauma Strap web loop
behind harness strap and pull
back around.
85283 (Rev. A)
1
Unzip Trauma Strap
pouches fitted on both
sides of the harness.
2
Connect the strap end
to the ring end, and
ensure strap buckle is fully
locked and secured.
3
Put your feet into
the loop that you
have made.
4
Stand on the loop
and examine
pressure on thighs.
5
Adjust strap as
necessary to accommodate
your height.