GUBI COBRA User manual

53-15-005-02 Assembly Instructions for Cobra Wall Lamp
CARE INSTRUCTIONS
TECHNICAL INFORMATION
TROUBLESHOOTING
Unplug power cord prior maintenance. To clean, use a soft cloth only.
Do not use any chemical or abrasive cleaners.
Light source: E14, recommended bulb 4 W LED 400 lumens. - Max LED 8W max
Turn power off when changing light bulb. Isolation class II. The lamp is not approved
for outdoor use or use in damp/wet rooms (IP20).
If lamp does not light, turn off the power. Check the bulb for a broken
filament. Replace bulb if necessary, then turn it on. If the lamp still does
not light, please contact customer service at the local dealer. If the
external flexible cable or cord of this lamp is damaged, it must be
replaced by a qualified electrician in order to avoid a hazard.
For enquiries contact GUBI A/S - CVR: 17940384
Klubiensvej 7-9. 2150 Nordhavn. Copenhagen, Denmark
T [phone] – [e-mail]
GUBI.COM

ASSEMBLY INSTRUCTIONS
for
COBRA TABLE LAMP
Cobra Table Lamp
005-023xx
Klubiensvej 7-9 / Pakhus 53
2150 Nordhavn, Copenhagen
Denmark
GUBI A/S
T: [phone]
CVR: 17940384
WWW.GUBI.DK
BULB REPLACEMENT
• Disconnect the power before replacing bulb.
TROUBLESHOOTING
• If lamp does not light, turn off the power. Check the bulb for a broken
lament. Replace bulb if necessary, then turn it on.
• If the lamp still does not light, please contact customer service at the local
dealer.
• If the external exible cable or cord of this lamp is damaged, it must be
replaced by a qualied electrician in order to avoid a hazard.
MAINTENANCE
• (Unplug power cord prior maintenance)
• To clean, use a soft cloth only.
• Do not use any chemical or abrasive cleaners.

ASSEMBLY INSTRUCTIONS
COBRA TABLE LAMP
1. 3.2. 4.
Unpack lamp. Plug lamp to main voltage.Place on stable ground. Push switch to turn lamp on and off.
1 Unpack lamp.
2 Place on stable ground.
SAFETY INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR PERSONAL INJURY
WARNING: Lighted bulb gets HOT! Do not touch while on.
CAUTION: Keep lamp away from curtains, bedding linens, and any other ammable materials.
Do not look directly at lighted bulb.
Turn off / unplug and allow lamp to cool before replacing bulb, cleaning or other maintenance.
Do not use in the bathroom or damp places.
CAUTION: TO REDUCE THE RISK OF FIRE, USE MAX. 40 WATT INCANDESCENT, E12, type b bulb,120V 60Hz AC ONLY.
Do not exceed recommended wattage.
CAUTION! IMPORTANT: LAMP MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN!
PREPARATION: Shut the power off.
Step 1
Step 2
3 Plug lamp to mains voltage.
4 Push switch to turn lamp on and off.
4
3
53-15-005-01 Mounting instr. Cobra Table lamp US