Hatco GLO-RAY GR-18 User manual

ITEM#
HATCO CORPORATION P.O. Box 340500 Milwaukee, WI 53234-0500 U.S.A.
( 00) 55 -0607 • [phone] • Fax ( 00) 543-7521 • Int’l. Fax [phone]
www.hatcocorp.com • E-mail: [e-mail]
GLO-RAY ® INFRARED FOODWARMERS
Models GRAH-18, -24, -30, -36, -42, -48, -54, -60, -66, -72, -84, -96, -108, -120, -132, -144 GRH-18, -24, -36, -48, -60, -72, -96
GRA-18, -24, -30, -36, -42, -48, -54, -60, -66, -72, -84, -96, -108, -120, -132, -144 GR-18, -24, -36, -48, -60, -72, -96
Hatco Glo-Ray Infrared Foodwarmers
safely keep all hot foods at optimum
serving temperatures longer. Foods do
not dry out or become discolored; even
the most delicate dishes hold that
“just-prepared” look. The Glo-Ray
pre-focused heat pattern directs heat
from a tubular element to bathe the
entire holding surface.
FLEXIBILITY
The continuous housings, up to 12'
(3658 mm) in width (aluminum only), are
very strong and eliminate the danger of
sagging. Sturdy stainless steel housings
are available up to 8' (2438 mm).
Available with shatter-resistant
incandescent lights that illuminate the
warming area. Remote infinite control
installation is recommended on all
installations.
Remote control enclosures are available
in several sizes, built in accordance
with UL Standards to accommodate
switches, indicator lights and wiring,
ready for installation.
Optional breath protectors can be
ordered with most aluminum Glo-Ray
models and meet NSF Standards for
display areas and buffet lines. Made of
shatterproof, easy-to-clean acrylic, they
provide a safe environment for the food.
The color option helps blend warmers
into any décor.
An on-off switch may be installed in
front or back of the unit to suit the
location. All Glo-Ray models are shipped
factory-assembled, with mounting tabs,
ready-to-install quickly and easily.
QUALITY
The following features assure the finest
performance for years to come:
• Available in widths from 18" to 12'
(457-3658 mm).
• Sturdy continuous aluminum housings
eliminate sagging.
• Pre-focused heat maintains serving
temperatures longer without continuing
to cook the food.
• Variety of models, configurations,
colors, finishes and accessories
provide unlimited design flexibility.
• Optional coated shatter-resistant
incandescent lights enhance brilliant
product display while safeguarding
food products from bulb breakage.
METAL SHEATHED ELEMENTS GUARANTEED AGAINST
BURNOUT AND BREAKAGE FOR TWO YEARS.
Model RMB-3F
with toggle
switch and
indicator light
Remote Control Enclosures
Model GRAHL-36 with optional
breath protectors and lights and
accessory adjustable tubular stand
Model GRAH-36 with optional
Designer color, infinite switch,
cord and plug set, and
accessory C-Leg stand
Form No. GR Spec Sheet
Printed in U.S.A.
September 2007
Model RMB-7D with
optional Designer color

ITEM#
PRODUCT SPECS
Infrared Foodwarmer
The Infrared Foodwarmer shall be a Glo-Ray®, manufactured by the
Hatco Corporation, Milwaukee, WI 53234 U.S.A.
With 24/7 parts and service assistance (U.S. and Canada only), the
Foodwarmer shall be a Glo-Ray Model ...., rated at ....watts, ....volts,
single phase and be ....inches (millimeters) in overall width.
The Glo-Ray shall consist of either a stainless steel or aluminum housing
and include as standard equipment four stainless steel shelf mounting
tabs and an on-off switch may be optionally installed to either the front
or rear of the unit.
The infrared heating element shall be tubular metal sheathed. The
foodwarmer shall be factory assembled ready for electrical installation.
Options and accessories shall include adjustable or non-adjustable
tubular stand, C-Leg stand, T-Leg stand, angle brackets, suspension
chain and fittings, breath protector, cord and plug set, indicator light,
incandescent light, and infinite controller – remote or built-in.
Aluminum Models: 18" thru 144" (457-3658 mm)
Stainless Models: 18" thru 96" (457-2438 mm)
2
1⁄2"
(64 mm)
6"
(152 mm)
Protective Grill Heating Element Reflector
TOP VIEW
Note: Add 3"
(76 mm) to
depth when
ordering lights.
FRONT VIEW
Power Location (36" (914 mm) flexible
metal conduit with 42" (1067 mm) leads)
Switch
END VIEW
GLO-RAY ® INFRARED FOODWARMERS
Models GRAH-18, -24, -30, -36, -42, -48, -54, -60, -66, -72, -84, -96, -108, -120, -132, -144 GRH-18, -24, -36, -48, -60, -72, -96
GRA-18, -24, -30, -36, -42, -48, -54, -60, -66, -72, -84, -96, -108, -120, -132, -144 GR-18, -24, -36, -48, -60, -72, -96
DIMENSIONS
18" to 144"W x 6"D x 21⁄2"H (457-3658 x 152 x 64 mm).
(Note: Add 3" (76 mm) to depth with light.) For special lengths,
consult factory.
Aluminum models from 18" through 12' (457-3658 mm). Available
in 6" (152 mm) increments up to 144" (3658 mm) maximum width.
VOLTAGE
120, 208 and 240 volts, single phase. Consult factory for Models
GRAH-84, GRH-96 and GRAH-96 in 120 volt, and models with
tandem elements (208 or 240V). Models with Lights rated 120,
(3-wire), 120/208 or 120/240 volts, single phase, (4-wire).
Export voltages available.
PLUG CONFIGURATION
MOUNTING REQUIREMENTS
Recommended Mounting Height – Standard Watt: 8"-11" (203-279 mm)
– High Watt: 11"-14" (279-356 mm)
MINIMUM SPACING –
Combustibles: 131⁄2" (343 mm) (high watt) or 10" (254 mm) (standard
watt) below, 1" (25 mm) above, and 3" (76 mm) to back wall.
Non-combustibles: 1" (25 mm) above, 10" (254 mm) (high watt with
infinite or indicator lamp), and 8" (203 mm) (high watt toggle or standard
watt) below. Must be installed in a pass through area. Units with remote
switches may be installed against a non-combustible back wall, flush
to an overshelf, and 8" (203 mm) to a surface below. Maximum 10"
(254 mm) setback from the front of an overshelf. Models with cords
must be installed 3" (76 mm) below an overshelf and 11" (279 mm)
(high watt) or 10" (254 mm) (standard watt) over a surface below.
120 volts only – Models 6' (1 29 mm)
or less with C-Leg or T-Leg stand or
Chain kit only.
ONE CONTROL BOX PER FOODWARMER.
NEMA 5-15P
REMOTE CONTROL ENCLOSURES
Model Width Toggle Switches
RMB-3 51⁄2" (140 mm) 2 Maximum
RMB-7 9" (229 mm) 4 Maximum
RMB-14 14" (356 mm) 6 Maximum
RMB-16 16" (406 mm) 3 Maximum
RMB-20 20" (508 mm) 3 Maximum
HATCO CORPORATION P.O. Box 340500 Milwaukee, WI 53234-0500 U.S.A. • ( 00) 55 -0607 • [phone]
Fax ( 00) 543-7521 • Int’l. Fax [phone] • www.hatcocorp.com • E-mail: [e-mail]
Printed in U.S.A.
Form No. GR Spec Sheet September 2007
OPTIONS (NOT FOR RETROFIT)
❑ Designer Colors, Aluminum Models 18" to 144" (457-3658 mm):
Warm Red, Black, Gray Granite, White Granite, Navy Blue, Hunter Green
❑Gloss Finishes, Aluminum Models 18" to 144" (457-3658 mm):
Smooth White, Gleaming Gold, Glossy Gray, Bold Black,
Radiant Red, Brilliant Blue
❑Indicator Light
❑Tandem Charge (Max. two elements end-to-end)
❑Extended Electrical Leads
❑Breath Protector (Aluminum models only)
❑Incandescent Lights (Add 3" (76 mm) to depth of warmer)
(Extra Lamps installed are two per foot minus one maximum –
requires Remote Control Enclosure) (Aluminum models only)
❑Halogen Bulbs in lieu of Standard Display Lights
❑Bright Annealed Lamp Reflector
❑Infinite Control† (Remote Recommended)
❑Remote Control Enclosure
†Maximum of 12.2 amps. Consult factory if rating of single element at
120 volts exceeds 1400 watts.
❑6' (1829 mm) Cord and Plug Set (120V only)
Available on models 6' (1829 mm) or less with C-Leg or T-Leg stand or Chain kit only.
ACCESSORIES
❑Adjustable Tubular Stands 10"-14" (254-356 mm)
❑Non-Adjustable Tubular Stands 10", 12", 14", or 16"
(254, 305, 356, or 406 mm) – Available in Designer colors
❑C-Leg Stands for Models up to 6' (1829 mm) (10" or 13
1⁄2
"
(254 or 343 mm) clearance)
❑T-Leg Stands for Models up to 6' (1829 mm) (10", 13
1⁄2
", 16", or 18"
(254, 343, 406, or 457 mm) clearance)
❑Adjustable Angle Brackets (Provides 1" – 2" (25-51 mm) clearance
above unit)
❑Chain Suspension
A uminum High Watt A uminum Standard Watt
Model Watt Model Watt Width Shipping Weight▲
GRAH-18 350 GRA-18 250 18" ( 457 mm) 6 bs. ( 3 kg)
GRAH-24 500 GRA-24 350 24" ( 610 mm) 7 bs. ( 3 kg)
GRAH-30 660 GRA-30 450 30" ( 762 mm) 8 bs. ( 4 kg)
GRAH-36 800 GRA-36 575 36" ( 914 mm) 9 bs. ( 4 kg)
GRAH-42 950 GRA-42 675 42" (1067 mm) 10 bs. ( 5 kg)
GRAH-48 1100 GRA-48 800 48" (1219 mm) 11 bs. ( 5 kg)
GRAH-54 1250 GRA-54 925 54" (1372 mm) 13 bs. ( 6 kg)
GRAH-60 1400 GRA-60 1050 60" (1524 mm) 14 bs. ( 6 kg)
GRAH-66* 1560 GRA-66 1160 66" (1676 mm) 16 bs. ( 7 kg)
GRAH-72* 1725 GRA-72 1275 72" (1829 mm) 17 bs. ( 8 kg)
GRAH-84* 2050 GRA-84 1500 84" (2134 mm) 19 bs. ( 9 kg)
GRAH-96* 2400 GRA-96 1725 96" (2438 mm) 21 bs. (10 kg)
GRAH-108* 2500 GRA-108* 1850 108" (2743 mm) 23 bs. (10 kg)
GRAH-120*•2800 GRA-120*•2100 120" (3048 mm) 26 bs. (12 kg)
GRAH-132*•3120 GRA-132*•2320 132" (3353 mm) 30 bs. (14 kg)
GRAH-144*•3450 GRA-144*•2550 144" (3658 mm) 33 bs. (15 kg)
SPECIFICATIONS
Stain ess High Watt Stain ess Standard Watt
Model Watt Model Watt Width Shipping Weight▲
GRH-18 350 GR-18 250 18" ( 457 mm) 7 bs. ( 3 kg)
GRH-24 500 GR-24 350 24" ( 610 mm) 7 bs. ( 3 kg)
GRH-36 800 GR-36 575 36" ( 914 mm) 10 bs. ( 5 kg)
GRH-48 1100 GR-48 800 48" (1219 mm) 12 bs. ( 5 kg)
GRH-60 1400 GR-60 1050 60" (1524 mm) 15 bs. ( 7 kg)
GRH-72 1725 GR-72 1275 72" (1829 mm) 19 bs. ( 9 kg)
GRH-96•2400 GR-96 1725 96" (2438 mm) 24 bs. (11 kg)
*Glo-Ray models 108" through 144" (2743-3658 mm) and 120-volt models of
GRAH-66, -72, -84, and -96 contain tandem elements individually controlled.
•Not available in 120 volts.
▲
Does not include RMB.