Havis-Shields C-VS-1000-TAH Configuration guide

INSTALL INSTRUCTIONS C-VS-1000-TAH
VEHICLE SPECIFIC CONSOLE
2007 CHEVY/GMC SUBURBAN/TAHOE/YUKON XL/YUKON
TOOLS REQUIRED:
Ratcheting wrench
Metric/Standard Socket Set
Standard Wrench Set
Power drill w/ 1/8” drill bit (optional)
Screwdriver set
T-20 torx bit
HARDWARE:
QTY DESCRIPTION PART #
1 OEM switch bracket CM001800-3
4 ¼-20 Serrated nut GSM30023
2 ¼-20 x ¾” Hex bolt GSM33001
2 #10 x ¾” Sheet metal screw GSM33195
1 Torx screw hardware kit C-HK-1
OEM switch bracket
CM001800-3
Switch cutout filler plate
CM001800-4
Supplied lighter plugs
C-VS-1000-TAH

C-VS-1000-TAH-INST-1-07
View of factory full-length console
with C-VS-1000-TAH
#1
Remove factory cup holder/accessory
pocket from console
#2
CAREFULLY separate trim bezel
from dashboard
#3
If your console is not equipped with
adjustable pedal, tow package, and power
brake switches proceed to step #13
N
ote:

C-VS-1000-TAH-INST-1-07
Using a flat head screwdriver
concentrate pressure on or around
the trim bezels “J” clips
Remove entire bezel and put aside. Remove factory trim screws to
remove the lower switch panel on
dashboard
#6
#5
#4
Unplug switch and set aside for
later install
Remove factory switch box from
trim panel
Using a small flat head
screwdriver, unclip fastener
#7 #9 #8
Install switch box into
C-VS-1000-TAH (if necessary)
View of factory console at this time Attach switch box to console
using T-20 torx screws. Do not
over tighten screws. This will
cause the switches to “stick” in
the ON position.
#12
#11#10

C-VS-1000-TAH-INST-1-07
Carefully drop backside of
console as shown
Install lighter plugs and extend
wires as necessary.
Slide C-VS-1000-TAH, front side
first, as shown above.
#15#14#13
#20
Align rear-mounting studs into
factory console holes and attach
using ¼” Serrated nuts.
Re-attach factory plug into
switch box
Be sure plug is secure and
wires are carefully routed so
not to chafe
#18
#17
#16
Route all wiring to console. Wire,
and install control heads and
accessories (Sold separately)
Attach middle of VS console to factory console
using ¼” x ¾” Hex bolts and serrated nuts. For
added support #10 x ¾” screws can be installed
on front side of console
#19
F
or added
support install
#10 x ¾” screws