HELLER HTF2000 User manual

CERAMIC OSCILLATING TOWER HEATER
USER MANUAL
Model Numbers: HTF2000
BEFORE OPERATING THIS PRODUCT, READ, UNDERSTAND, AND
FOLLOW THESE INSTRUCTIONS.

IMPORTANT
Read and follow the instructions in this user manual even if you feel you are familiar with the product, and
find a place to keep it handy for future reference.
For your convenience record the complete model number (located on the product identificationplate)and
the date you received the product, together with your purchase receipt and attach to the warranty and
service information. Retain in the event that warranty service is required.
NOTE: The rating of this product (as marked on the product identification plate) is based on specific
loading tests. Normal use or the use of other recommended attachments may draw significantly less
power.
IMPORTANT SAFEGUARDS
When using any electrically powered product, basic safety precautions should always be
followed, including the following:
PLEASE READALL INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT
WARNING!: - to reduce the risk of fire, electrical shock or injury to persons or property:
•Carefully read all instructions before operating your new product for the first time and save for
future reference.
•Remove and safely discard any packaging material and promotional labels before using the
appliance for the first time.
•To eliminate a choking hazard for young children, remove and safely discard the protective cover
fitted to the plug of this appliance.
•Always operate the product from a power source of the same voltage, frequency and rating as
indicated on the product identification plate.
•This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
•Keep out of reach if children and do not allow them to operate this appliance.
•Close supervision is necessary when the product is used by or near children or invalids. Children
should be supervised to ensure that they do not play with the appliance.
•This product must not be located immediately below a socket outlet, and should not be used in
the immediate vicinity of water, such as bathtubs, washbowls, swimming pools etc. where the
likelihood of immersion or splashing could occur.
•WARNING: In order to avoid overheating, do not cover the heater, or operate in close
proximity to curtains, etc. Check air inlets and outlets from time to time for accumulated
dust.
•CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on and off by the utility.
•Do not switch the appliance on until it properly installed as described in this manual.
•Do not leave the heater running unattended.

•Do not use the appliance outdoors.
•Do not use if you have wet or damp hands.
•Never use the appliance on or near hot surfaces.
•Do not operate the product if it is dropped, damaged or showing signs of product malfunction.
•Do not operate the product with a damaged plug or cord. Return the complete product to the
place of purchase for inspection, refund or replacement.
•If the supply cord is damaged, the cord must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid hazard.
•Do not immerse or expose the product or flexible cord to rain, moisture or any other liquid.
•Switch off and unplug from outlet when the product is not in use and before cleaning the unit.
•To avoid personal injuries or property damage, do not insert any body parts (e.g. finder) or
objects through the air inlet or outlet openings when the heater is operating.
•This product is intended for normal domestic/household use only and should not be used for
industrial purposes.
•From time to time, please check the cord for damage. Never use the appliance if the cord or any
part of the appliance shows signs of damage.
•Repairs to electrical appliances should only be performed by a qualified electrician. Improper
repairs may place the user at serious risk.
•Do not run the main cable under carpets, rugs, etc.
•Do not allow the mains cable to hang over sharp edges or come into contact with hot surfaces.
•Never immerse the product in water or any other liquids.
•Before cleaning the appliance, ensure it is unplugged from the power and that it is completely
cooled.
•Do not clean the appliance with abrasive chemicals.
•Always disconnect the heater when moving it from one location to another.
•The use of attachments or accessories not recommended or sold by the product distributor may
cause personal or property hazards or injuries.
•Do not use the heater in reach of a shower, bath or a swimming pool.
•Heater is not located immediately below a socket-outlet.
•The surfaces of the heater are very hot during operation.Avoid contact with the wind outlet. Use
handles and knobs if necessary.
•Do not twist or wrap the power cord around the appliance as this may cause the insulation to
weaken and split, particularly where it enters the unit. Fully unwind the cord before use as a
coiled cord may overheat.
•Use of an extension cord is not recommended. However, if it is absolutely necessary ensure the
cord is short as possible (long cords coiled up can overheat and cause tripping accidents).
•Do not use the appliance on the same socket or electric circuit with other electrical appliances so
as to prevent the circuit from being overloaded, which will cause fire. Please do not prolong the
power cords by yourself or use movable socket.
•Ensure the cord is fully extended before use and accommodate it so that it is not in touch with
any part of the heater.

•Do not use the heater in areas such as garages where petrol or other flammable substances are
used or stored. Do not use the heater when flammable sprays, liquids, solvents and glues or
flammable fumes may be present.
•Keep combustible materials such as furniture, pillows, bedding, clothes and curtains at least 1m
away from the appliance.
•Avoid touching the heater body whilst the heater is on. Do not move the appliance while it is
functioning in order to avoid overheating with the additional risk of fire.
•Switch off and unplug from outlet when not in use, before assembling or disassembling parts and
before cleaning. Remove by grasping the plug - do not pull on the cord.
•Do not use the appliance for other than its intended use.
•Do not leave the appliance unattended when switched on.
•Always use the heater on a leveled surface.
•Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of
overheating).
•Children aged from 3 years should be kept away unless continuously supervised.
•Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
•Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided
that it has been placed or installed in its intended normal operating position and they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved.
•Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
•Always use a fireguard when children and infirm persons can come into contact with the heater.
•Never sit or stand on the heater.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
BEFORE FIRST USE
•Remove all packaging and check the appliance for any damages during transportation. If the unit
appears to be any damages, please take back the damaged heater to the place of purchase for a
replacement, unwind the power cord before switch on.
•Ensure a power socket is available to power the heater and that the heater is not directly located
under the power socket.,
•Ensure the heater is placed on a level surface with enough clearance from its surroundings.
•Do not place the heater on LONG PILE CARPET OR FLOKATI RUGS. Use a heat board if
necessary.
CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.

PRODUCT FEATURES
GETTING STARTED
Before first use
•Unpack: This product has been packaged to protect it against transportation damage. Unpack
the appliance and keep the original packaging and materials in a safe place. It will help prevent
any damage if the product needs to be transported in the future, and you can use it to store the
appliance when it is not in use. In the event that the packaging is to be disposed of , please
recycle all packaging materials where possible.
•Safe packaging disposal: Plastic wrapping can be a suffocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and disposed of safely.
•Cord: Inspect the power cord and plug, and all other parts of the appliance, for visual damage.
Do not use the appliance if anything appears to be damaged or not working properly. In case of
damage, return the product to your local store or our after sales support centre.
8
1
3
2
5
4
7
6
Parts of the heater
1. Selector Knob
2. Front Shell
3. Air Outlet
4. Base
5. Handle
6. Back Shell
7. Oscillation Switch
8. Power Cord
NOTE: Due to continued product improvement, images and illustrations in this manual may vary
slightly from the product purchased. All images in this manual are for reference purposes only. Parts
are not necessarily pictured to scale.

•Documentation: Make sure you have read and understood all instructions and warnings in this
manual. Refer to the Product Overview, opposite, to familiarize yourself with the product and
identify all parts. Pay particular attention to the safety instructions on the previous pages.
•First time use:
When turning on your heater for the first time, it is normal for the heater to emit a ‘new heater’
smell, which will quickly pass. This is no cause for concern. Ensure good ventilation.
OPERATING INSTRUCTIONS
Place the heater in an upright position on a firm, level, dry and heat-resistant surface, taking into
consideration all relevant safety information on the previous pages.
The appliance is suitable for providing auxiliary heating. It is not suitable for use on its own to heat large
spaces.
Ensure that there is sufficient distance from the wall. fixtures and other appliances. The distance must be
least 1m at the front of the heater to exclude the risk of fire.
Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit.
POWER AND HEAT SETTINGS
THERMOSTAT
Set the thermostat to "max." and operate the appliance until the desired
room temperature is reached. Turn the thermostat anticlockwise until the
appliance switches off with an audible "click".
This set temperature will be kept almost constant by the appliance
switching on and off automatically.
Please note that the appliance does not switch on unless the thermostat setting is higher than the room
temperature.
SYMBOL
FUNCTION
0
OFF
Fan without Heat Settings
1
Fan with low Heat Settings (1000W)
2
Fan with High Heat Settings (2000W)
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after
having not been used for a long period of time, the heaters may emit some smell and fumes. This will
disappear when the heater has been on a short while.

OSCILLATION
Turn on and off oscillation function using the oscillation switch located at the back of the heater.
“O”----- OSCILLATION OFF
“－”----- OSCILLATION ON
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance automatically when the heater
falls over, or is at an excessive angle from the horizontal. This helps prevent accidents, and the heater
will resume operation when it is put back upright.
OVERHEAT PROTECTION
This heater is protected with thermal cutoff protection that switches off heating automatically in case of
severe overheating (e.g. something covering the heater). In this case, waiting to the appliance cool and
removing the objects. Then the thermal cutoff will automatically reset, heating as normally. Check for
damage to the appliance, the cord and the plug. If there is no damage, plug the unit back in and switch it
on as described above. If the heater still does not turn on, please contact Customer Service for
assistance.
CLEANING & MAINTENACE
The heater requires regular cleaning to ensure trouble free operation:
•Unplug the heater from the mains supply before cleaning.
•Ensure that the heater has been allowed to cool before cleaning.
•Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
•Do not allow any water or other liquid to enter the housing or control panel.
•Ensure the heater is dry before plugging back into the mains supply.
Warning: In order to avoid overheating, do not cover the heater.
WARNING - Fabric, clothing or other flammable materials may ignite if placed
against or in close proximity to the heater. No flammable materials should be placed within
120cm of the front or heat outlet and 50cm of sides or rear of the heater. Do not cover the heater.
This appliance is for indoor use only. Do not use outdoors.
STORAGE
When the heater is not used for long periods of time, it should be protected from dust and stored in a
clean dry place.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they
may damage the surface finish of the heater.

SPECIFICATIONS
Model
Description
Voltage
Wattage
HTF2000
CERAMIC OSCILLATING TOWER HEATER
220-240V~
2000W
CUSTOMER SERVICE
Australian Customer Service
GAF Control (Sales) Pty Ltd
P.O Box 19
Altona North, Victoria, 3025
Phone: [phone]
Hours: 9am-5pm (EST) Mon-Fri
www.gafcontrol.com.au
*This product may vary slightly to the product illustrated due to ongoing product development.