Herman Miller Celle User manual

Read this
while
adjusting
your
Celle
™
chair

Seat Height
Lever under right side of seat
To raise: While taking your weight off chair, lift lever up.
To lower: While seated, lift lever up.
Adjust the seat height so your feet rest flat on the floor or footrest.
Tilt Tension
Knob below front side of seat
To increase: Turn knob clockwise.
To decrease: Turn knob counterclockwise.
Set the tilt tension to control the resistance you feel when
leaning back.
Seat Depth
Lever under left side of seat
While taking your weight off chair, lift lever and adjust seat pan
forward or back. Release lever to lock in position.
Adjust your chair’s depth so the seat edge doesn’t hit the
back of your legs.
HMI.MC Seat Depth
Arm Height
Lever on outside lower base of each arm
To raise or lower arms: Raise lever to unlock arm, adjust arm,
release lever to lock.
Adjust chair’s arm height to support your arms and take
weight off your shoulders.
Arm Angle
Front of each armpad
To pivot arms in or out: Grasp front end of armpad and
pivot it to the left or right.
Adjust chair’s arms inward for support while using a keyboard;
adjust arm out for support when using a mouse.

Arm Width
Rear of each armpad
To adjust: Grasp rear portion of armpad and adjust arm in or out.
Adjust width of chair’s arms to support your arms and take
weight off your shoulders.
Forward Tilt
Horizontal tab under left front side of seat
To position chair forward: Recline and flip tab down.
To resume horizontal position: Recline and flip tab up.
Engage the forward tilt for support when performing task-intensive
work such as keyboarding.
Tilt Limiter
Vertical tab under left front side of seat
To engage: Recline and move tab up to define the limit of recline.
To release: Lean forward and press tab back.
Engage the tilt limiter when you want to sit in an upright or
partially reclined position.
HMI.MC Tilt Limiter
Lumbar Height
Side edges of lumbar support
To raise or lower: Grasp side edges of lumbar support,
slide lumbar support up or down to desired height.
Adjust the height of the lumbar so it supports the natural
curve of your spine.
Lumbar Depth
Knob in center of lumbar support
To increase lumbar support: Turn knob clockwise.
To decrease lumbar support: Turn knob counterclockwise.
Adjust the depth of the lumbar so it supports the natural
curve of your spine.
HMI.MC Tilt Limiter

User
information:
Installers
do not remove
©2005 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 1B25VX-B O.CJ6200
® lis among the registered trademarks of Herman Miller, Inc.
™ Celle is among the trademarks of Herman Miller, Inc.
Users: Retain This Information for Future Reference
Instructions on this card show all possible adjustments. Specific adjustments vary according
to chair model. To view the Celle chair user-adjustment video, visit www.HermanMiller.com
Maintenance
A periodic inspection of chair components and fasteners should be made to ensure that
the chair is structurally intact and functioning properly. Damaged and broken parts should
be replaced and loose fasteners tightened.
For more information about our products and services or to see a list of dealers, please
visit us at www.HermanMiller.com or call [phone].