Herman Miller Verus User manual

Adjustment Guide1HermanMiller Verus® Chair
To limit tilt range:
Turn clockwise to limit the level
of recline
To release tilt limiter:
Turn counterclockwise to increase the
level of recline
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
To lock the tilt:
Tilt (3 & 4) Push down the lever to lock
the backrest in place at one of the
preset angles.
Tilt (8) Turn counterclockwise to lock
the backrest in place at one of the
preset angles.
To unlock the tilt:
Tilt (3 & 4) Pull up the lever to unlock
the tilt.
Tilt (8) Turn the knob clockwise to
unlock the tilt.
Engage the tilt lock when you want to lock the backrest in an upright or one
of the preset angles.
HermanMiller
Verus® Chair
To raise:
While taking your weight o chair,
li lever up.
To lower:
While seated, li lever up.
At the proper height, your feet should rest flat on the floor.
Seat Height: Paddle-shaped lever on right side
To increase depth:
Pull lever out, slide thighs forward to
adjust seat; release lever.
To decrease depth:
Pull lever out, push seat back and
release lever.
In the proper position, you will have approximately three-ngers of clearance
between the back of your knees and the seat edge.
Seat Depth: Lever under right side of seat
Tilt Lock: Knob/Level below le side of seat
Available on Self-adjusting tilt (), ()
& Tilt with tension control ().
Tilt Limiter: Knob below right side of seat
Available on Self-adjusting tilt ().

Adjustment Guide2HermanMiller Verus® Chair
To adjust height on suspension back:
Slide lever up and down to desired
height.
To adjust height on TriFlex back:
Slide adjustable back support up and
down to desired height.
Lumbar Height: Lever on adjustable lumbar support
Only available on some models.
To raise or lower arm:
Push button and pull arms up or down
to desired height.
For maximum comfort, your arms should make contact with the armpad
without any lift at your shoulders.
Arm Depth & Width:
Only available on some models.
To adjust arm depth:
Grasp arm pad, push forward or back to
desired position.
To adjust arm width:
Grasp armpad and pull in or push out.
Arm Height: Button located on arm stalk under each arm pad
To increase tension:
While seated, turn knob forward
(toward + sign).
To decrease tension:
While seated, turn knob backward
(toward – sign).
Set the tilt tension to control the resistance you feel when leaning back.
For the Self-adjusting Tilt with the Tilt lock or Tilt limiter, the tension is
pre-loaded to adjust to the user.
Tilt Tension: Long stem on right side with knob
Available on Tilt (8) Tension control
with tilt lock.