Herman Miller Eames User manual

Power Driver3/4” Socket Head wrench 1/4” Allen Wrench
How to assemble
your table.
HermanMiller
The Collection
Eames®Table Assembly
For more information about our products and services or to see a list of dealers, please visit us at
hermanmiller.com or call [phone].
© 2013 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. 400604 - L.
® Y, Eames are among the registered trademarks of Herman Miller, Inc.
OR
#3 Phillips Screwdriver
Top Surface
Threaded Rod (qty : 2)
Jam Nut (4)
Locating Washer (2)
Retainer Ring (2)
Lock Washer (2) Screw (8)Cap Screw (6)
Spreader Assembly
Top Casting (qty : 2)
Leg (qty : 4) Tube (qty : 2)
Parts Included
Tools Required
1.3
Remove shipping rail, when attached, before attaching top casting(s).
1.4
Position top casting(s) on table top, align holes in top casting(s) with holes in table top.
1.1
Remove parts from carton using care to avoid damaging tabletop. Remove cardboard fillers
and discard.
1.2
Invert table top on a clean padded surface.
Step 1
Step 2
2.1
Insert (4) screws on each side and tighten.
HermanMiller Eames®Table Assembly Instructions1

HermanMiller Eames®Table Assembly Instructions2
3.1
Thread jam nut on one end of threaded rod until jam nut stops.
Step 3
3.2
Threaded rod end with jam nut all the way into the top casting. Tighten jam nut against top
casting.
4.1
Place tube over rod onto top casting.
Step 4
5.1
Place spreader assembly into slot in tubes, when applicable.
6.1
Insert legs into slots in the tubes.
Step 5 Step 6

HermanMiller Eames®Table Assembly Instructions3
7. 1
Place ratainer ring in slot on the legs and spreader assembly.
Note: Retainer ring fits inside of tube
Step 7
7. 2
Place locating washer over legs and spreader assembly.
7.3
Insert cap screw and tighten
8.1
Place lock washer and threaded nut on threaded rod and tighten the nut to 45 ft lbs.
Step 8
9.1
Place table in upright position.
Step 9