Herman Miller FT194.A Installation instructions

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Zand Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b2t8s rev D.
1
YCanvas Office Landscape® Cable Shield Installation and
Disassembly for Recycling Instructions
FT194.A
FT194.B
Vertical Cable Shield (12)
Horizontal Cable Shield (12)
Parts Included
Vertical Cable Shield:
Press Vertical Cable Shield into each side of pass-through
opening in back-to-back Frame Stiles.
Vertical Cable Shield
Vertical Cable
Shield
Frame Stile
Assembly Instructions:
IMPORTANT: Save these instructions for layout changes.

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Zand Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b2t8s rev D.
2
Horizontal Cable Shield:
Horizontal Cable
Shield
Horizontal Cable
Shield
Horizontal Cable
Shield
Cable Trough
Wire Harness
Support Rail
Horizontal Cable
Shield
Frame Rail
Press Horizontal Cable Shield into opening
in each side of Frame Rail.
Press Horizontal Cable Shield into opening
in Wire Harness Support Rail.
Press Horizontal Cable Shield into
opening in Cable Trough.

Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Zand Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b2t8s rev D.
3
Disassembly for Recycling:
Materials Identication and Segregation:
Where possible, plastic components are marked with ASTM recycling codes.
Use these codes to identify material type for recycling. Non marked components
should be treated as mixed plastic. Ferrous metals can be identied using a
small magnet for recycling. Non-ferrous metals should be separated and recycled
separately.
To disassemble product, reverse the above installation steps.