Herman Miller 1BKTM2-A User manual

Parts Included
Tools Required
HermanMiller
Canvas Channel Gallery Panels
Installation
How to assemble your Gallery Panels
Wall Start Gallery Panel PH40 Hook
Screw Light Seal
Power Driver # 2 Phillips Bit
Driver (Extended)
Carpenter’s Level
Step Step 
Assembly Instructions:
. Adjust foot to ” from floor to bottom of frame.
”
. Slide plate into frame through slot in bottom of frame until end of
plate is flush with bottom of frame.
Assembly Instructions1HermanMiller 1BKTM2 rev A

. Place top cap temporarily on frame to adjust gallery panel up
or down to align the top of the panel with the top cap.
. Secure Frame to gallery panel by fully tightening screws.
Plate
Frame
Fastener
Light Seal
(in one of two
positions)
. Complete steps - above.
. Attach PH hooks to gallery panel using # screws provided.
. Align panels and lock hooks together.
. Level system before installing additional components.
Assembling -Piece Gallery Panels
Step  Step 
Step 
. Peel o backer tape and attach light seal to edge of frame so the
screw holes are unobstructed. Then adjust glides on gallery panel
to align pilot holes with holes of the wall start and frame and attach
gallery panel with () # screws provided in hardware kit, not fully
tightening screws.
For more information about our products and services please visit us at
hermanmiller.com or call ()  .
© Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A. Part No. BKTM  A
Assembly Instructions2HermanMiller 1BKTM2 rev A