Herman Miller Action Office User manual

Parts Included
Tools Required
HermanMiller
Action Oce®Lateral File Installation
How to assemble Action Oce® Lateral File
Lateral File Le and Right Hand Hanger
Clip Assemblies
Tape Measure
Step 1
Assembly Procedure Step 2
. Install hanger clip assembly on hanger frame or wall insert by
inserting lock tabs in slots compressing resilient pads and sliding down.
. Lock tab will engage in hanger frame or wall insert and resilient pad
will maintain contact preventing accidental dislodging.
. Hanger clip assembly may be removed by applying inward pressure to
compress resilient pad and sliding clip assembly up.
Resilient
pad
Hanger Frame
or Wall Insert
Screw
Product
Key Hole Slot
Anti-Dislodging
Clip
Installed Position
Lock Tab
Hanger Clip
Assembly
Hanger Clip
Assembly
Panel
. Two persons are required to install product on hanger clip assembly.
. Insert screws in key hole slots and move down to engage screws in
slots. Top screw will depress anti-dislodging clip and clip will capture
screw and prevent the product from being accidentally dislodged.
. Product may be removed by depressing anti-dislodging clip and liing
product up and out.
3/8” Box or
Socket Wrench
Assembly Instructions1115200 rev HHermanMiller

Assembly Instructions2115200 rev HHermanMiller
Step 3 (For 42” and 48” Wide Only)
. Make sure screws are loosened, but not removed, on the
inside of the drawer back panel.
. Open drawer fully. Reach hand behind the back of le drawer
to the gear rod.
. Pull up on gear rod until fully seated in the gear track.
. Tighten screws with /” wrench.
. Repeat steps . - . for opposite side.
. Shut drawer to ensure front closes completely to conrm the
gear alignment is correct.
. If uneven, loosen screws and repeat step  in entirety.
Step 4
. Vertical spacing of clips to install more than one lateral le must be
. inches from top of clip on upper le to top of clip on lower le.
. Lowest lateral le must be installed rst.
. Be sure that lateral les are level and top screw is captured by the
anti-dislodging clip.
. Vertical spacing between lateral les must be a minimum of
. inches.
.
.
Clip
Lateral File
Hand
Screw
Location
Screw
Location
Pull Up Engage
Gears
Gear Rod