Hib Eclipse round Manual

Thank you for purchasing this HiB product.

Please read through these instructions carefully and refer back to them during installation to ensure that

your product is tted safely and that it retains its high quality nish.

Please retain this leaet for future reference.

Before drilling, ensure there are no hidden cables or pipes in the wall and that the domestic mains supply

to which the mirror is to be connected is turned o.

These products are suitable for installation in zones: 2 OZ

Please see Figure 4 on the back page for details.

Eclipse & Libra Magnifying Mirrors

Eclipse Round: Art No. 21100

Ver No. 1.0 Nov 2015

Eclipse Square: Art No. 21200

Libra: Art No. 21400

Fixing Instructions

Installation

1. Position the magnifying mirror in a suitable location (according to the zonal diagram

overleaf, Figure 4), ensuring that the domestic electrical mains supply is within reach of the

electrical entry point of the product. Do not position in direct sunlight as the magnifying

eect of the mirror may pose a re hazard.

2. Remove the wall bracket from the base of the mirror via the xing(s) on the base of the unit

(see mounting diagram, gures 2&3).

3. Using the wall bracket as a guide, carefully mark the required drilling locations using a

soft pencil, ensuring it is level. Remove the wall bracket. Please ensure all marked drill

positions accurately match up with the xing points of the wall bracket before drilling.

4. Using a suitable drill bit, drill holes in the marked positions to a suitable depth. If drilling

through tile, use a ceramic drill bit.

5. Insert wall plugs level with the surface of the wall. If tting to a tiled surface, wall plugs

should be inserted below the tile surface to avoid cracking. NB. For plasterboard walls,

specialist xings should be purchased, available from any DIY or hardware store.

6. Fix wall bracket into wall plugs.

7. Connect the domestic mains supply to the terminal box according to the wiring diagram

below (gure 1).

8. Place the mirror onto the wall bracket and secure into place using the xing(s) on the mirror

base – take care not to trap wiring when assembling the mirror onto the wall bracket.

9. Switch on the domestic electrical mains supply to the mirror.

Operation Instructions

Libra - To turn illumination on, simply pull the front of the mirror away from the wall. To turn

the illumination o, simply push the mirror back towards the wall into the o position.

Eclipse - Illumination is switched on and o by the rocker switch on the underside of the mirror

base.

live

earth

neutral

MAINS SUPPLYLUMINAIRE

Wiring Diagram

Live supply can be Red or Brown

Earth supply is Green and Yellow

Neutral supply can be Blue or Black

Live is Brown

Earth is Green and Yellow

Neutral is Blue

Wiring Diagram (Fig. 1)

hib.co.uk 3

Libra (Fig. 2)

Mounting Diagram

Eclipse (Fig. 3)

Mounting Diagram

Wall bracket

Fixing

Point

Rocker switch

Mirror base

Fixing Instructions

Wall bracket

Mirror base

Fixing

Point

This product is suitable for installation in zones: 2 OZ

All installations must comply with guidelines which are based on a zonal concept. The diagram above

illustrates this concept and must be followed to ensure the safe installation of electrical appliances in the

bathroom. These regulations apply to domestic installations only. Installations must be made in accordance

with the current IEE wiring regulations and relevant building regulations. HiB recommends that all electrical

bathroom products should only be tted by a suitably qualied, Part P registered electrician.

©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and

make sure they are as accurate as possible. In the interest of continuous product development, HiB reserves the right to alter specications as necessary. E & OE.