HiBoost C27G-CP User manual

1%
#530051"
We Improve Your Mobile Signals
User's
Manual
C27G-CP/SS
Made in HUAPTEC

E“
#330051"
Table of contents
Thcmk you for purchasing HiBoost's Eosy Vehicle-ZS/SS cell phone signol booster
kit.
Eosy Vehicle-ZS/SS can improve the reception signal strength both voice and
data service for any vehicle, Eosy Vehicle-ZS can support all 26 and 36 bonds,
Eosy Vehicle-58 can support all 26,56 and 46 bonds oround US.
If you need any assistance during product installation please contact our
technical support at 972-870-5666 or email us at [email protected].
How it works ............................................................................................................. 3
HOW to install ............................................................................................................. 5
OUtdOOl‘ ontenno .................................................................................................... 4
Vehicle booster ....................................................................................................... 4
|ndoor ontenno ....................................................................................................... 4
Power supply .......................................................................................................... 4
LEDs indicotion ........................................................................................................... 4
Specifications ............................................................................................................. 5
Troubleshooting ......................................................................................................... 6
Warranty and Warning .............................................................................................. 6
Warranty .................................................................................................................. 6
Warnings .................................................................................................................. 7

a)
II
30051"
\
How it works
HiBoost Easy Vehicle-ZS/SS provides a reliable two-way cellular coverage by
improving signal strength in any kinds of vehicle where cellular reception is
weak or unreliable.
The system amplifies the signal from the nearest cellular tower and retransmits it
at a higher power level within the vehicle area. This manual provides simple
installation instructions that will make your cellular booster kit set in record time.
Package contents:
. Easy Vehicle-ZS/SS 50 dB cell phone booster
. 5 dB magnetic antenna mounting on roof of vehicle
. Patch antenna used for interior of vehicle
. DC power adapter with 6' cable
Easy Vehicle-28/5S Magnetic antenna Patch antenna DC power adapter
How to install
The parts will be installed one at a time before connecting all together. There are
4 installations: outdoor antenna, booster, indoor antenna, and power supply.
Afterwards, you will need to connect the outdoor/indoor antenna and the power
adapter to the booster.
" Magnetic Antenna: to connect with"Outdoor"port
Suggested location: about 200m/8inch from glass in the rear
Sever Antenna: to connect with"|ndoor"port
Suggested location: at"3/4"height ofthe glass
Power
supply:
to
connect
\
2134
With"D012V"p0rt
u.
3/4
Vehicle Booster
Power supply:
to connect with vehicle lighter

E“
#330051"
Outdoor antenna
. Magnetic antenna is adopted. The proposed location is about 20cm or 8inches
at the rear of the car. If you have a larger vehicle, try installing at the rear roof.
. The function of outdoor antenna is to receive the signal from the base station,
transfer it through the feeder to booster. On the contrary it transmits the signal
back to the base station from the booster.
Vehicle booster
. The vehicle booster should be hidden in the corner of the car, near the power
supply.
. The booster is a full-duplex amplifier which amplifies the signal both inside and
outside the vehicle.
Indoor antenna
- Small Patch Antenna which has 2dBi gain is adopted. The proposed location is
at 5/4 height of the glass which is shown in the installation graph. If your
vehicle is larger, the proposed location is where the signal is weak.
. The function of the indoor antenna is to transmit the enlarged signals to mobile
phones and also back to the booster.
Power supply
. 12V power supply is adopted. The vehicle charger can also work. The booster
can be directly fed by the vehicle's power.
LEDs indication
The following graph shows the ports of C27G-CP, because two bands are
supported simultaneously, the panel has 2 alarm indicators. For C27G-58, the
panel has 5 alarm indicators because it supports 5 bands. For each alarm
indicator, the status and definition is the same.
_Ae_.fl._........_
=—=
"\__F£
1. Connect with outdoor antenna 2. Connect with the power supply
3. Connectwith indoor antenna 4. PCS alarm indicator
5. CDMAaIarm indicator

y)
H
\
BOOST
Status
Alarm
It is working in linearity.
Green Warning: Input signals may be not enough, so please check on
coverage effect, do not do anything if it is good; otherwise please
check the donor antenna position.
It is working in linearity. (A little stronger input signals or slight self
oscillation have occurred.)
Orange Solution: Please adjust antennas till find the ”edge point” (I.E. the
Alarm LED shall stay at green color, with intention of turning Orange),
stop immediately when the LED color changes which can provide the
best coverage.
There are strong input signals or severe self oscillation to lead that
booster breaks down. Please check the troubleshooting to get
Red
solutions.
Flashing
Specifications
C27G-CP UL Frequency
C27G-CP DL Frequency
C27G-58 UL Frequency
C27G-SS DL Frequency
C27G-CP Supported
C27G-CP Supported
Max .Gain
Max .Output Power
Automatic Level Control
ALC LED
C27G-CP I/O Port
C27G-SS I/O Port
Impedance
Environment Conditions
C27G-CP Dimensions
C27G-5S Dimensions
C27G-CP/SS Weight
Power Supply
824-849/ 1850-1910
869-894/ 1930-1990
698-716/776-787/824-849/1850-1910/1710-1755
728-746/ 746-757 / 869-894/ 1930-1990/ 2110-2155
CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO
CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE
50dB
C27G-CP 21.6dBm(UL)/5.0dBm(DL)
C27G-SS 23.2dBm(UL)/4.8dBm(DL)
215dB, auto shut off after 15dB
Orange @ ALC 1~5dB, Red @ ALC 15~20dB, Flashing
Red @LED off after Sseconds
SMA-Female
SMA-Female
500hm
IP40
4.7*5.5*1.4inch/120*135*54mm
4.7*7.8*1.4inch/120*198*34mm
$5.5Lbs / 2.5Kg
DC12V/3A

E“
#330051"
Troubleshooting
Problem Solution
Why is there still no signal Check if the power supply of the vehicle is off.
after installing the vehicle Also check to make sure all connections are not
booster? loose.
The signal is not stable after
.
Check
that
the
outdoor
signal
is
stable.
turning on the booster power.
The Alarm LEDs continue to Check to make sure vehicle is not parked too
flash close to a cell tower.
Check that the booster is turned on and the DC
Signal booster has no power power outlet is plugged into the cigarette lighter
adapter.
Warranty and Warning
Warranty
30-Day Money-Back All HiBoost products are protected by a 30-day money-back
guarantee. If for any reason the performance of any product is not acceptable,
the product may be returned to the reseller with a dated proof of purchase.
3-Year Warranty HiBoost Signal Boosters and kits are warranted for 3 years.
Customers can choose to return the Signal Boosters and kits directly to the
manufacturer at the purchase expense, with a dated proof of purchase and a
Returned Material Authorization (RMA) number supplied by HiBoost.
HiBoost will supply two options, repair or replace. HiBoost will take charge of
delivery for the consumers located within the continental US.
This warranty does not apply to any Signal Boosters or kits determined by
HiBoost to have been subjected to misuse, abuse, neglect, or mishandling that
alters or damages physical or electronic properties. Failure to use a surge
protected AC Power Strip with at least a 1000 Joule rating will void your
warranty.
All HiBoost products that are packaged with other HiBoost accessory products
are intended for resale and used as a single use. Such product kits are required
to be sold to the end users or subsequent reseller as packaged. RMA numbers
may be obtained by contacting Technical Support at 972-870-5666

a)
H
\
BOOST
Warnings
Users must follow the below principles:
A Do not dismantle machine, maintain or displace accessories by you,
because in this way, the equipment may be damaged or even get an electric
shock.
A Do not open the booster; touch the module of booster, even not to open
the cover of module to touch the electronic, the components will be damaged
due to electrostatic.
A Please keep away from heating-equipment, because the booster will
dissipate heat when it is working. And do not cover booster with anything that
influences heat-dissipation.
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider
and have your provider's consent. Most wireless providers consent to the
use of signal boosters. Some providers may not consent to the use of this
device on their network. If you are unsure, contact your provider.
You MUST operate this device with approved antennas and cables as
specified by the manufacturer. Antennas MUST be installed least 20 cm
(8 inches) from any person.
You MUST cease operating this device immediately if requested by the
FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be
inaccurate for calls served by using this device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

Address: 6210 N Belt Line Rd.,Ste.11O Irving, TX 75063 Phone:[phone]
E-mail : [email protected] Web site : www.huaptecus.com
Ii
“mlec Designed and Produced By Huaptec