Hoist Fitness RPL-5301 User manual

CATALOG NUMBER 0208-002
RPL-5301 ADDENDUM
OWNER'S MANUAL
Fax
[phone]
[phone]
[phone]
JULY, 2008
Note: Both Serial Number and Model Number are Required when Ordering Parts
RECORD SERIAL NUMBER HERE
Customer Service
ADDENDUM
READ THIS FIRST!
THE FOLLOWING PAGES WILL SUPERCEDE THE
EXISTING PAGES IN THE RPL-5301 MANUAL
RPL-5301

RPL-5301 ASSEMBLY
OWNER'S MANUAL
PAGE 26
MACHINE ADJUSTMENT
MAJOR ADJUSTMENT:
LOOSEN JAM NUTS (26, 27) AND TWIST TIE RODS (16)
IN/OUT TO ADJUST THE PRESS ARMS TO THE PROPER
HEIGHT. ONCE THE PROPER HEIGHT IS REACHED AND
THE PRESS ARMS ARE OF EQUAL HEIGHTS, BE SURE
TO RE-TIGHTEN JAM NUTS.
TWIST THE TIE RODS (16) EITHER
- CLOCKWISE TO DECREASE
PRESS ARM HEIGHT
OR
- COUNTER-CLOCKWISE TO
INCREASE PRESS ARM HEIGHT.
26
27
16 16
26
27
34 1/2"
w/ RUBBER FOOT
w/o RUBBER FOOT
34 1/4"

0208 - 003
OWNER'S MANUAL
Customer Service
Fax
[phone]
[phone]
[phone]
Note: Both Serial Number and Model Number are Required when Ordering Parts
RECORD SERIAL NUMBER HERE
CATALOG NUMBER
**WARNING !**
TO PREVENT POSSIBLE TIPPING, BOLT THIS UNIT TO THE
EXERCISE FLOOR. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH.
RPL-5301
PLATE-LOADED CHEST PRESS

PAGE 01
OWNER'S MANUAL
INSTRUCTIONS .....................................................................
RPL-5301 ASSEMBLY
FRAME ASSEMBLY ..............................................................
MACHINE ADJUSTMENT......................................................
PRE-ASSEMBLY....................................................................
DECAL PLACEMENT.............................................................
DECAL REFERENCE.............................................................
PART LIST...............................................................................
ABBREVIATIONS...................................................................
BOLT SIZING CHART............................................................
WASHER SIZING CHART......................................................
MAINTENANCE SCHEDULE.................................................
GENERAL MAINTENANCE INFORMATION........................
WEIGHT TRAINING TIPS.......................................................
CONTENTS
LIMITED WARRANTY............................................................
EXERCISE LOG......................................................................
02
04
26
28
29
30
33
36
37
39
41
42
43
44
45

PAGE 02
OWNER'S MANUAL
assembly instructions to locate any possible errors made during assembly.
RPL-5301 ASSEMBLY
If you are unable to correct the problem, call your authorized HOIST dealer.
ensure correct operation. If you experience problems, first recheck the
INSTRUCTIONS
Be sure to have your serial number and this manual when calling. When all
parts have been accounted for, continue on.
Ratchet Wrench
Two People
Hex Key Wrench Set
TOOLS REQUIRED
Level
Tape Measure
Rubber Mallet
Adjustable Wrench
1/2", 9/16" and 3/4" Sockets
Before beginning assembly please take the time to read instructions
thoroughly. Please use the various lists in this manual to make sure that
all parts have been included in your shipment. When ordering, use part
number and description from the lists. Use only HOIST replacement parts
when servicing. Failure to do so will void your warranty and could result
in personal injury.
HOIST equipment is designed to provide the smoothest, most effective
exercise motion possible. After assembly, you should check all functions to

PAGE 03
OWNER'S MANUAL
RPL-5301 ASSEMBLY
***THIS PAGE WAS INTENTIONALLY LEFT BLANK***

PAGE 04
OWNER'S MANUAL
RPL-5301 ASSEMBLY
FRAME ASSEMBLY

FRAME ASSEMBLY
- HAND TIGHTEN HARDWARE.
PAGE 05
OWNER'S MANUAL
RPL-5301 ASSEMBLY
NOTE:
- REPEAT ASSEMBLY FOR OPPOSITE SIDE.
59
3
74
50
2
49
83
28
59
9
10

60 72
60
58
12
47
12
47
15
72
58
- WRENCH TIGHTEN HARDWARE.
RPL-5301 ASSEMBLY PAGE 06
FRAME ASSEMBLY
NOTE:
OWNER'S MANUAL

OWNER'S MANUAL
RPL-5301 ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
FRAME ASSEMBLY
PAGE 07
9
8
58
69
63
32
58
82
15