Hoist Fitness HF4603 User manual

Note: Both Serial Number and Model Number are Required when Ordering Parts
OWNERS MANUAL
Customer Service
Fa x
[phone]
[phone]
[phone]
HF4603
AB/LOW BACK
CATALOG NUMBER
RECORD SERIAL NUMBER HERE
1205-001

INSTRUCTIONS .........................................................................
PRE-INSTALLED PARTS ...........................................................
FRAME ASSEMBLY ....................................................................
PARTS LIST .................................................................................
HARDWARE LIST .......................................................................
DECAL REFERENCE .................................................................
BOLT SIZING CHART .................................................................
WASHER SIZING CHART ..........................................................
MAINTENANCE SCHEDULE .....................................................
GENERAL MAINTENANCE .......................................................
LIMITED WARRANTY .................................................................
CONTENTS
2
3
4
5
6
7
8
9
10
11
13
Page - 1 HF4603 Assembly
A S S E M B LY
M A N U A L

Page - 2
A S S E M B LY
M A N U A L
I N S T R U C T I O N S
Socket Wrench
7/16", 1/2", 9/16", and 3/4" Sockets
Crescent Wrench
Rubber Mallet
Tape Measure
TOOLS REQUIRED
Before beginning assembly please take the time to read the
instructions thoroughly. Please use the various lists in this
manual to make sure that all parts have been included in your
shipment.
Use only Hoist replacement parts when servicing.
Failure to do so will void your warranty and could result in
personal injury.
Hoist equipment is designed to provide the smoothest, most
effective exercise motion possible. After assembly, you should
check all functions to ensure correct operation. If you
experience problems, first recheck the assembly instructions to
locate any possible errors made during assembly. If you are
unable to correct the problem, call your authorized Hoist dealer.
Be sure to have your serial number and this manual when
calling. When all parts have been accounted for, continue on .
When ordering use the part number and description
from the lists.
HF4603 Assembly

Page - 3
A S S E M B LY
M A N U A L
PRE-INSTALLED PARTSPRE-INSTALLED PARTS
HF4603 Assembly

Page - 4
A S S E M B LY
M A N U A L
HF4603 Assembly

Page - 5
A S S E M B LY
M A N U A L
PA R T S L I S T
HF4603 Assembly
Key # Qty Part Number Description
1 1 26-STD-04-0735 Seat Frame
2 1 26-STD-04-0738 Swing Arm Support Assembly
3 1 26-STD-04-0740 Swing Weight Mount Assembly
4 1 26-STD-04-0739 Swing Arm Assembly
5 1 26-STD-01-1122 Rear Support Bar
6 1 26-STD-04-0736 Foot Support Assembly
7 1 26-STD-04-0524 7" Roller Pad Mount Assembly
8 1 26-STD-04-0737 Seat Mount Assembly
9 1 26-STD-07-0101 Seat Pad
10 1 26-STD-04-0741 Range of Motion

Page - 6
ASSEMBLY
MANUAL
HARDWARE LIST
HF4603 Assembly
F 1 26-STD-11-0023 Locking Pull Pin (for Seat Adjuster)
G 1 26-STD-11-0024 Pull Pin (For ROM)
H 2 26-STD-06-0129 Bumper- 45mm L x 25 W x 8.0t
J 2 26-STD-06-0163 Round End Cap - 50.8mm
K 1 26-STD-06-0170 Endcap - .38mm x 50mm
L 4 26-STD-06-0135 Easy Glide Adjuster Sleeve - 26.5mm x 49 x 204L
M 2 26-STD-06-0136 Endcap - 38mm
N 2 26-STD-06-0074 Endcap - 45mm
O 2 19-GRP-205CLOSED Comfort Grip - ID 25.4mm x 205 L
P 2 26-STD-08-0032 Flange Oilite - 35mm x 25.2mm x 20mm h
Q 1 17-RLR-18 Roller Pad - 5" OD x 45mm ID x 18" L
R 5 11-HEX-123 Hex Bolt- 1/2"-13UNC x 3" L
S 2 11-HEX-38(16)1 Hex Bolt- 3/8"-16UNC x 1" L
T 2 11-HEX-516134 Hex Bolt- 5/16"-18UNC 1 3/4" L
U 2 13-FND-38112 3/8 Fender Washer
V 10 13-FLT-12SAE Flat Washer- 1/2" SAE
W 2 13-FLT-516USS Flat Washer- 5/16" USS
X 2 13-LOK-38 3/8" Lock Washer
Y 5 12-LOK-12 Nylon Locknut 1/2"
Z 1 030-0303002 Roll Pin - 3/8" Dia. x 1 3/4" L
AA 4 26-STD-06-0027 Plastic Fender Washer 60mm x 25.7mm x 3.0t
AB 1 26-STD-06-0185 Plastic Washer 35mm x 25.2mm x 5.0t
AC 1 26-STD-06-0153 Bumper-63mm x 26 x 16h
AD 2 17-RLR-7 Roller Pad - 4" OD x 23mm ID x 7" L

Page - 7
ASSEMBLY
MANUAL
DECAL REFERENCE
SERIAL # DECAL ; Always refer to the number shown on your piece
of equipment when talking to customer service or ordering parts.
These decals have been attached to this piece of equipment to
provide information regarding operation, safety and
maintenance. Before use, take the time to read these decals.
HF4603 Assembly
TO CHANGE
DIRECTION
OF EXERCISE
MOVEMENT
PULL PIN
021-0003105-Y
MOVING PARTS
CAUTION
MAINTENANCE
COMMERCIAL
Weekly
6
Monthly
Daily
Months
Yearly
Inspect;
Cables or Belts
and their
tension
Inspect;
Cables or Belts
and their
tension
Inspect;
Links, Pull Pins,
Snap Locks,
Swivels,
Weight Stack
Pins
Inspect;
Links, Pull Pins,
Snap Locks,
Swivels,
Weight Stack
Pins
Clean;
Upholstery
Clean;
Upholstery
Inspect;
Accessory Bars
and Handles
Inspect;
Accessory Bars
and Handles
Inspect;
All nuts and
Bolts Tighten
if Needed.
Inspect;
All nuts and
Bolts Tighten
if Needed.
Inspect;
All Decals
Inspect;
All Decals
Inspect;
Anti-Skid
Surfaces
Inspect;
Anti-Skid
Surfaces
Clean &
Lubricate; Guide
Rods with a
Teflon (PTFE)
based lubricant
(Superlube)
Clean &
Lubricate; Guide
Rods with a
Teflon (PTFE)
based lubricant
(Superlube)
Lubricate;
Seat Sleeves,
Turcite Bushings,
Linear Bearing
Lubricate;
Seat Sleeves,
Turcite Bushings,
Linear Bearing
Repack with
Grease Linear
Bearings
Repack with
Grease Linear
Bearings
Clean & Wax;
All Glossy
Finishes
Clean & Wax;
All Glossy
Finishes
Replace;
Cables, Belts
and Connecting
Parts.
Replace;
Cables, Belts
and Connecting
Parts.
NOTICE
WARNING
USE ONLY GENUINE HOIST REPLACEMENT
PARTS. FAILURE TO DO SO WILL VOID
WARRANTY AND COULD RESULT IN PERSONAL
INJURY OR EVEN DEATH. THERE IS A RISK
ASSUMED BY INDIVIDUALS WHO USE THIS
TYPE OF EQUIPMENT. TO MINIMIZE THE RISK
ALWAYS FOLLOW THESE SIMPLE RULES.
1. READ & UNDERSTAND ALL
ENCLOSED INSTRUCTIONS b for
using this quipm nt.
2. INSPECT EQUIPMENT BEFORE
EACH USE. R plac all parts at th
first signs of w ar or damag . If in
doubt about a c rtain part, DO NOT
us th quipm nt until th part is
r plac d. Failur to r plac worn or
damag d parts may r sult in injury.
3. FOLLOW ROUTINE
MAINTENANCE SCHEDULE
4. CONSULT YOUR PHYSICIAN
BEFORE STARTING ANY
EXERCISE PROGRAM. Warm up
prop rly b for ngaging in w ight
r sist nc training. Stop x rcising if
you f l faint or dizzy.
5. TO PREVENT THE POSSIBILITY
OF SERIOUS INJURY, KEEP CLEAR
OF ALL MOVING PARTS. Do not
att mpt to fr any jamm d part by
yours lf. Obtain assistanc in ord r to
avoid possibl injury.
6. Tak your tim and do not rush th
x rcis . Practic prop r br athing,
hold your br ath.
7. CHILDREN SHOULD NOT BE
ALLOWED TO USE THIS
EQUIPMENT. To avoid possibl
injury, childr n should b k pt at a saf
distanc wh n this quipm nt is in us .
T nag rs should not us this
quipm nt without adult sup rvision.
8. CALL YOUR AUTHORIZED
HOIST DISTRIBUTOR if you hav
any qu stions on th prop r us or
maint nanc of this quipm nt.
NEVER
021-0003091
021-0003230
021-0003104
SERIAL # DECAL
021-0003150
1-800-548-5438
00-00-000000
www.hoistfitness.com
SERIAL # 00-00-000000

HF4603 Assembly Page - 8
B O L T S I Z I N G C H A R T
A S S E M B LY
C A T A L O G

HF4603 Assembly
Page - 9
ASSEMBLY
CATALOG
WASHER SIZING CHART
SMALL, SAE, 26mm
LARGE, USS, 34mm
LARGE, USS, 25mm