HOMCOM Children ATV User manual

INfac010V01_UK
370-051
BATTERY P OWERED RIDE- ON
BATTERY POWERED RIDE-ON
Children ATV
ASSEMBLY INSTRUCTION
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY

Battery
Charger
6V4AH
6V500mA
Suitable age:
Load Capacity:
Speed:
Size of car:
37-96 months (3 years+)
Under 25kg
2.5 km/h
66 * 43 * 43 CM
About Your New Ride-On │ 1
SPECIFICATIONS:
On the purchase of your new Ride-On.
This ride-on will provide your child with many miles of riding of enjoyment.
To help assure you and your rider a safe ride we ask you to please read this
manual carefully, and keep it for future reference.
Follow the recommendations in this manual, they are designed to improve
the safety and operation of your ride-on car and it’s rider.
Power way: Charging type
Charge time: 8-12 hours

The following safety hazards may result in serious injury or death:
• Never leave child unattended. Direct adult supervision is required. Always
keep child in view when child is in vehicle.
• Never use in roadways, near streets, motor vehicles, steps, bodies of water,
sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night, or in
the dark.
• Never use in unsafe conditions such as snow, rain, loose dirt, mud, sand, or
gravel, otherwise may result in an unexpected accident such as tipping over,
and could damage the electrical system or battery
• Not to be used in traffic.
• This toy should be used with caution since skill is required to avoid falls or
collisions causing injury to the user or third parties.
• This toy is unsuitable for children under 36 months due to its maximum
speed; Maximum user weight is 25kg.
• This toy has no brake.
User Notice │ 2
WARNING!
SAFETY
● Non-rechargeable batteries are not to be recharged.
● Rechargeable batteries are to be removed from the toy before being charged.
● Rechargeable batteries are only to be charged under adult supervision.
● Different types of batteries or new and used batteries are not to be mixed.
● Batteries are to be inserted with the correct polarity.
● Exhausted batteries are to be removed from the toy.
● The supply terminals are not to be short-circuited.
BATTERY INFORMATION
• CHOKING HAZARD - Small parts. Not suitable for children under 36 months.
The product contains small parts, keep children away when assembling.
• ADULT ASSEMBLY REQUIRED.
• Always remove protective material and poly bags and dispose before
assembly.
• Protective equipment should be worn. Always wear shoes and sit in the seat
when operating the vehicle.
• Only drive on level ground. Never use on the lawn.
• Never leave a child unattended.
• Keep your hands, hair, and clothes away from moving parts.

11
10
6
5
7
8
9
7
7
9
2
4
1
3
3
6
8
7
5
Parts Diagram │ 3

10
PART
NO.
REMARKS
PART NAME
Q’ty (pcs)
Vehicle body
Handle bar
Wheel
Seat
Out bushing
Hubcap
Ø10 washer
Lock nut
Inner bushing
Spanner
Charger
Parts List │ 4
Assembly tools required:
Screwdriver
(Not included)
Spanner
1
1
2
1
2
2
4
2
2
1
1
1
2
3
4
5
6
7
8
9
10
11

Attach the Handle Bar │ 5
Front Bottom View
Remove all the parts from the rear axle.
1. Insert the steering column on the hande bar into the hole on the vehicle body.
2. Insert the bent end of steering column in the hole on the steering linkage. Press the
handle bar down until you hear it “click” into place.
3. Turn the vehicle body downside up. Plug the connectors into each other.

Attach the Front Wheels │ 6
After assembling any wheel to the axles, please check the
GAP
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the whee l
and the wheel can’t run smoothly, the motor will be broken
easily! Then you need to decrease one or two washers to
make sure the wheel can run smoothly!
124 5 6
7
3
Spanner
Assembly tools required:
1. Slide a Ø10 washer onto the front axle.
2. Slide a inner busing, ring end first onto the front axle.
3. Slide a wheel onto the front alxe. Ensure the inner bushing match up with wheel.
4. Slide a outer busing onto the front axle.
5. Slide a Ø10 washer onto the front axle.
6. Tighten a lock nut to the end of the front axle with a spanner.
7. “Snap” the hubcap to the wheel.
Remove all the parts from the front axle.
Repeat the above procedure to assemble the other normal wheel.

Connect the Power Supply │ 7
2. Plug the red wire connector into the terminal on the battery.
3. Replace the seat.
1. Turn the lock located at the back of the seat, and remove the seat
1
2
3

● Press the forward button down, the ride-on moves forword.
● Release from the button to brake or slow down.
Use Your Ride-on │ 8
Use the vehicle on generally level ground ONLY!
DO NOT Use the vehicle on Lawn space!
Forward button
Forward button

Charging │ 9
Important! Recycle the dead battery responsibly. The battery contains lead acid
(electrolyte) and must be disposed of properly and legally. It is illegal in most areas to
incinerate lead acid batteries or dispose of them in landfills. Take it to a federal or
state-approved lead acid battery recycler, such as local automotive battery retailer.
Do not throw the battery away with your regular household waste!
• The POWER SWITCH must be turned in OFF position when charging.
• Before the first use, you should charge the battery for 4-6 hours. Do not recharge the
battery for more than 10 hours to avoid overheating the charger.
• When the vehicle begins to run slowly, recharge the battery.
• After each use or once a month minimum recharge time as 8 to 12 hours, less than 20
hours at most.
• Use the only rechargeable battery and charger supplied with your vehicle. NEVER
substitute the battery or the charger with another brand. Using another battery or charger
may cause a fire or explosion.
• Do not use the battery or charger for any other product.
• ONLY an adult is allowed charge and recharge the battery!
• This product with Charging Protection : when charging, all functions will be
WARNING!
cut off.
1
Rear Bottom View
2
1. Plug the charger port into the input socket (the socket is under the left rear fender).
2. Plug the charger plug into a wall outlet. The battery will begin charging.
Battery Disposal
The battery will eventually lose the ability to hold a charge. Depending on the amount of
use, and varying conditions, the battery should operate for one to three years.

.
Problem Possible Cause Solution
Vehicle does not run
Vehicle does not run
very long
Vehicle runs sluggishly
Vehicle needs a push
to go forward
Difficult shifting from
forward to reverse or
vice-versa
Loud grinding or clicking
noises coming from
motor or gear box
Battery low on power
Thermal fuse has tripped
Battery connector or wires
are loose
Battery is dead
Electrical system is damaged
Motor is damaged
Battery is under charged
Battery is old
Battery is old
Vehicle is overload
Vehicle is being used in harsh
conditions
Poor contact of wires or
connectors
“Dead Spot” on motor
Motor or gears are damaged
Recharge battery.
Battery low on power
Reset fuse, see <Fuse>
Check that the battery connectors are firmly plugged
into each other. If wires are loose around the motor
contact your distributor please.
Check that the battery connectors are firmly plugged
into each other. If wires are loose around the motor,
contact your distributor please.
A dead spot means the electric power is not being
delivered to the terminal connection and the vehicle
needs repair. Contact your distributor please.
Attempting to shift while the Completely stop the vehicle and shift, see <Use Your
vehicle is motion Ride-On>
Check that the battery connectors are firmly plugged
into each other when recharging
Replace battery, contact your distributor please.
Replace battery, contact your distributor please.
Replace battery, contact your distributor please.
Reduce weight on vehicle.
Avoid using vehicle in harsh conditions, see <Safety>.
Recharge battery, contact your distributor please.
Contact your distributor please.
Contact your distributor please.
Contact your distributor please.
Battery will not
Contact your distributor please.
recharge
Charger feels warm
when recharging
Battery connector or adapter
connector is loose
Charger not plugged in
Charger is not working
This is normal and not a
Check that the battery connectors are firmly plugged
cause for concern
into each other.
Check that the battery charger is plugged into a
working wall outlet.
Completely read through this manual and the troubleshooting guide table before calling. If you
still need help resolving the problem Contact your distributor please.
Troubleshooting Guide │ 10

The battery features a thermal fuse with a rest fuse that will automatically trip and cut all
power to the vehicle if the motor, electric system or battery is overloaded. The fuse will
reset and power will be restored after the unit is turned OFF for 20 seconds and then turned
ON again. If the thermal fuse trips repeatedly during normal use, the vehicle may need
repair. Contact your distributor please.
To avoid losing power, follow these guidelines:
● Do not overload the vehicle.
● Do not tow anything behind the vehicle.
● Do not drive up steep slopes.
● Do not drive into fixed objects, which may cause the wheels to spin, causing the motor to
overheat.
● Do not drive in very hot weather, components may overheat.
● Do not allow water or other liquids to come in contact with the battery or other electric
components.
● Do not tamper with the electric system. Doing so may create a short, causing the fuse to
trip.
• It is parents' responsibility to check main parts of the toy before using, Must
regularly examine for potential hazard, such as the battery, charge, cable or
cord, plug, screws are fastening enclosure of other parts and that in the event
of such damage, the toy must not be used until that damage had been properly
removed.
• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Recharge the battery after each use. Only an adult can handle the battery.
Recharge the battery at least once a month when the vehicle raider is not being
used.
• Do not wash the vehicle with a hose. Do not wash the vehicle with soap and
water. Do not drive the vehicle in rainy or snowy weather. Water will damage
the motor, electric system and battery.
• Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a
non-wax furniture polish. Do not use car wax. Do not use abrasive cleaners.
Fuse
Maintaining │ 11
• When not using, all the electrical source should be turn off. Turn off the power
switch and disconnect the battery connection.