HOMCOM 370-239V70 User manual

50
ASSEMBLY INSTRUCTION
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
4 Wheels Dump Truck
Battery Powered Ride-on
INflb001_UK
370-239V70
Read and understand this entire manual before using!
Please keen this manual for future reference as it contains important information.
Before first time use. charge the battery for at least 4-6 hours, but no more than 10
hours.

100-240V 50/60Hz 0.3A
12V #550*2(12000RPM)
12V 1000mA
3-6
3-6
50
About your new vehicle
On the purchase of your new ride-on.
To ensure the user rides safely, please read these instructions carefully. Keep this manual for
future reference.
●Do not recharge non-rechargeable batteries.
●Before charging rechargeable batteries, remove them from the vehicle.
●Batteries must be charged under adult supervision.
●Different types of batteries or new and used batteries must not be mixed.
●Insert batteries with the correct polarity.
●Remove dead batteries from the ride-on.
●Do not short-circuit the supply terminals.

19
19
11 11
21 22
23 S
P
W
1
2
3
7
7
8
8
4
5
9
18
20
15
17
14
10
11
6
6
12
16
13

PREVENTING POSSIBLE INJURY OR DEATH:
● NEVER LEAVE CHILDREN UNATTENDED. ADULT SUPERVISION IS
ALWAYS REQUIRED. Keep children in your view when they use this vehicle.
● A certain amount of skill is required when using this vehicle, preventing falls or
collisions. This ride-on must be used with caution.
● Protective equipment must be worn.
● Never use on roads, steep slopes or steps, or near swimming pools.
● Always wear shoes and sit on the seat.
● Do not use in traffic.
● Not for children under three years because of its maximum speed. Maximum
load is 50 kg.
● This ride-on has no brake.
● Keep children in safe riding areas:
● Never use on roads, near motor vehicles, on lawns or on steep slopes and steps.
Do not use near swimming pools.
● Only use on flat surfaces. Safe locations include inside your house, garden or
playground.
● Never use in the dark – children could collide with obstacles. Only use this ride-on
in the daytime or in a properly lit area.
● It is prohibited to change the circuit or add other electric parts.
● Regularly inspect wires and connections of the vehicle.
● When the vehicle is moving, ensure children do not touch or get near the wheels.
● This ride-on has adjustable seatbelts. Teach children how to properly fasten the
seatbelt before using.

1
2
3
4
5
Remove all parts from the front axle.
1.Place a Ø12 washer onto the front axle.
2.Place the front wheel onto the front axle.
3.Place a Ø10 washer onto the front axle.
4.Tighten a locknut to the end of the front axle with a spanner. DO NOT over
tighten.
5.'Snap' the hubcap to the wheel.
Repeat the above procedure to assemble the other rear wheel.

1
Insert the rear axle into the correct hole on the rear side of the
body.

2
4
5
3
1
1. Plug the connector of the rear box to the connector from the body. Fit
the rear gearbox onto the rear axle.
2. Place the driving wheel onto the rear axle.
3. Slide a Ø10 washer onto the rear axle.
4. Tighten a locknut to the end of the rear axle with a spanner.
Repeat for the other wheel.
5. 'Snap' the wheel covers to the wheels.
24V rear gear box

1-2. Fit the front bumper to the vehicle body, then insert four 4x14 black
screws and tighten.
3. Insert the handle into the holes on the dash.
4. Plug the sound unit connector on the steering wheel into the
connector on the body. Hide the connectors and wires into the
steering wheel.
5. Fit the steering wheel to the steering wheel base on the body.
6-7. Line up the holes on the steering wheel with the holes on the
steering wheels base, then insert the M5x40 machine screw. Fasten a
nut on the opposite end of the screw with a screwdriver.

2
4
Bottom of seat
3
Connect the Power Supply & Attach the Seat
1. Plug the connecter from the vehicle body
into the connector on the battery.
2. Place the seat back into the vehicle
body.
3-4. Press and hold the button on the
bottom of the seat until it is attached to
the body.