Home Styles 88 5181 16 User manual

88 5181 16
Arts & Crafts Student Desk
PART LIST
HARDWARE LIST
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Home Styles Consumer Assistance Line 888-680-7460 and 877-831-0319
[email protected]
A.
Top Unit
1 pc.
Bolt
8 pcs. (+1 extra )
Flat Washer
8 pcs. (+1 extra )
Spring Washer
8 pcs. (+1 extra )
Key Wrench
1 pc.
Wood Screw
2 pcs. (+1 extra)
B.
Side Frame
1 pc.
C.
Side Frame
1 pc.
D.
Stretcher
1 pc.
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level

Assembly Instructions
STEP 1
Turn the Top (A) upside down
and place it on a soft cloth.
Remove all the drawers.
STEP 3
STEP 4
Turn the unit over to its’ upright position.
Slide the drawers into position
Remove the Pull Handles that are installed
on the inside of the drawers and re-install
them on the outside of the drawer.
(See figure 2)
.
(Figure 2)
(Figure 3)
Flat Washer
Spring Washer
Bolt
Key Wrench
(Figure 1)
Bolt
Spring Washer
Flat Washer
F
Wood Screw
A
STEP 2
Attach Side Frame (B) and (C)
to Top (A) with Flat Washers,
Spring Washers and Bolts.
Tighten only half way. (See figure 1)
Attach Stretcher (D) to the unit
with Wood Screws.
Tighten all bolts.
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Key Wrench in a safe place as you may need to tighten up the Bolts in the future.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
* Use a soft cloth between these parts and the floor.
A
B
C
D
To level the unit, adjust the adjustable
levelers on the bottom of unit. (See figure 3)