Home Styles 88 5700 30 User manual

Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
Part List
IMPORTANT NOTE.
Tools required for assembly : Level
This product is made of sturdy, high quality aluminum
and will provide years of enjoyment. Do not use power tools
to assemble and only tighten bolts until they are snug.
Over tightening can cause damage to the aluminum.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occurring to the parts.
We have taken great care in the design of this product and
request that you carefully and strictly follow our assembly
instructions to ensure a completed product as it was designed.
88 5700 30
Dining Table
A.
Top
1 pc.
B.
Leg
4 pcs.
Hex Wrench
1 pc.
Spring Washer
16 pcs. (+1 extra)
Flat Washer
16 pcs. (+1 extra)
Cover
1 pc.
C
Stretcher
1 pc.
M6x20
Head Cap Bolt
16 pcs. (+1 extra)

Assembly Instructions 2/2
Figure 1 Figure 2
STEP 1
Place Top (A) upside down on a soft cloth.
Attach Legs (B) to Top (A) with Flat Washers,
Spring Washers and Head Cap Bolts,
tightening the bolts only half way.
(See Figure 1)
Cover
Figure 3
A
B
Head Cap Bolt
Flat Washer B
B
B
Spring Washer
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Nuts in the future.
* Use a soft cloth between these parts and the floor.
* Do not use power tools to assemble and do not over tighten the bolts and nuts.
* Do not tighten all the bolts and nuts until each part is properly assembled.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
C
Head Cap Bolt
Flat Washer
Spring Washer
STEP 3
Turn the unit over to its’ upright position.
Cover the umbrella hole with Cover.
To level the unit, adjust the adjustable levelers
on the bottom of the legs. (See Figure 3)
STEP 2
Attach Stretchers (C) to unit with Flat Washers,
Spring Washers and Head Cap Bolts, tightening
the bolts only half way. (See Figure 2)
Tighten all Head Cap Bolts used in Steps 1 and 2.