Home Styles OutdoorPatio 6660-80 User manual

Hardware List
Spring Washer (large)
10 pcs. (+1 extra)
Spring Washer
4 pcs. (+1 extra)
Flat Washer (large)
10 pcs. (+1 extra)
Flat Washer
4 pcs. (+1 extra)
6660-80
Arm Chair
IMPORTANT
Carefully remove all the parts from the carton and place them
individually on a soft cloth to prevent scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
This product is made of aluminum. Do not use power tools
above 8 volts to assemble and only tighten bolts until snug.
Over tightening can damage the aluminum.
B.
Seat
1 pc.
E.
Leg
4 pcs.
D.
Arm
1 pc.
C.
Arm
1 pc.
Part List
A.
Back
1 pc.
Tool(s) required for assembly: Level
Hex Wrench
1 pc.
Small Hex Wrench
1 pc.
M6x15
Head Cap Bolt (short)
4 pcs. (+1 extra)
M8x20
Head Cap Bolt
8 pcs. (+1 extra)
M8x30
Head Cap Bolt (long)
2 pcs. (+1 extra)
styles Customer Service: www.homestylesfurniture.com,home
[email protected], 888-680-7460

Assembly Instructions 2/3
IMPORTANT
Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.
Do not tighten all the bolts until each part is properly assembled.
The unit must be level to work properly. Use the included adjustable levelers to level.
Keep Hex Wrench as the bolts may need to be tightened in the future.
STEP 1
Attach Seat (B) to Back (A) with
Flat Washers (large), Spring Washers (large)
and Head Cap Bolts (long),
tightening bolts only halfway.
(See Figure 1)
Flat Washer (large)
Spring Washer (large)
Head Cap Bolt (long)
STEP 2
Attach Legs (E) to unit with
Flat Washers (large), Spring Washers (large)
and Head Cap Bolts, tightening bolts only halfway.
Flat Washer (large)
Spring Washer (large)
Head Cap Bolt
Figure 1
A
B
E
E
E
E

Assembly Instructions 3/3
STEP 3
Turn unit to its upright position.
Attach Arms (C) and (D) to unit with Flat Washers, Spring Washers and Head Cap Bolts (short),
tightening bolts only halfway.
Tighten all Head Cap Bolts used in Steps 1, 2 and 3.
Level unit by adjusting the adjustable levelers on bottom of legs. (See Figure 2)
Flat Washer
Spring Washer
Head Cap Bolt (short)
Figure 2
C
D

NEVER
use glass cleaners on
finished furniture. Ammonia
chemically attacks the finish.
allow liquids to remain on furniture.
Absorption causes parts to warp
and split and finishes to delaminate.
NEVER
CARE INSTRUCTIONS
Do not use rubber
based placemats.
PREVENT
DISCOLORING
Do not use commercial
waxes and polishes.
PREVENT
YELLOWING
Do not place hot
objects on surface.
PREVENT
FINISH DAMAGE
Do not write
directly on surface.
PREVENT
MARKING
Do not use power tools
above 8 volts to assemble.
PREVENT
CRACKING
Do not place
in direct sunlight.
PREVENT
FADING
with a soft cloth moistened
in lukewarm soap and water.
Buff with a dry clean cloth.
CLEAN
homestyles will provide replacements free of charge for missing or damaged parts within 2 years of purchase.
Digital images of the defective parts may be required. If the product was not purchased from an authorized retailer,
homestyles is under no obligation to provide replacement parts. Parts are not available for fully assembled items nor
are parts available for sale. Replacements for missing or damaged parts may be requested via contact info below.
styles Customer Service: www.homestylesfurniture.com,home
[email protected], 888-680-7460