Home Styles Cabin Creek 88 5411 15 User manual

Hardware List
Head Cap Bolt
30 pcs. (+1 extra)
Hex Wrench
1 pc.
Small
Hex Wrench
1 pc.
Flat Washer
20 pcs. (+1 extra )
Spring Washer
30 pcs. (+1 extra )
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level
Home Styles Consumer Assistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
B.
Stretcher
2 pcs.
A.
Cabinet
1 pc.
C.
Stretcher
1 pc.
D.
Stretcher
1 pc.
88 5411 15
Cabin Creek
Executive Desk
F.
Drawer
1 pc.
E.
Side Frame
2 pcs.
Wood Screw
for Drawer
6 pcs. (+1 extra)
Machine Screw
4 pcs.
Pull Handle
2 pcs.
Big Flat Washer
10 pcs. (+1 extra )

Assembly Instructions 2/3
IMPORTANT
* Do not tighten up all the screws until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the floor.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
STEP 1
Attach Stretchers (B), (C) and (D) to Side Frame (E)
with Head Cap Bolts, Spring Washers and Flat Washers.
Tighten Head Cap Bolts only halfway. (see Figure 1)
Attach Side Frame (E) to unit with Head Cap Bolts, Spring Washers and Flat Washers.
Tighten all Head Cap Bolts.
STEP 2
A
E
E
B
B
C
D
Flat Washer
Spring Washer
Head Cap Bolt
Figure 1
Figure 3
Remove the outside drawers.
Remove the Pull Handles that are installed on
the inside of the drawers and re-install them on
the outside of the drawer. (see Figure 2)
Remove the center drawer by pushing the plastic lever on its’ left side up, pushing the plastic
lever on its’ right side down and pulling the drawer open slowly. (see Figure 3)
Figure 2

Turn the unit over to its’ upright position.
Slide the drawers into position.
Figure 5
To level the unit, adjust the adjustable
levelers on the bottom of unit. (see Figure 5)
Assembly Instructions 3/3
Attach unit onto Cabinet (A)
with Head Cap Bolts,
Spring Washers
and Big Flat Washers.
STEP 4
Head Cap Bolt
Spring Washer
Big Flat Washer
STEP 5
A
STEP 3
F
Wood Screw for Drawer
Attach Drawer (F) to Drawer
with Wood Screws for Drawer.
Attach Pull Handles to Drawer
with Machine Screws.
(see Figure 4)
Figure 4
Place Cabinet (A)
upside down on a soft cloth.