Home Styles Blanche 450795 User manual

Tool(s) required for assembly: Phillips screwdriver
D.
Back Panel
2 pcs.
45 9507-
Kitchen Cart
IMPORTANT
Carefully remove all the parts from the carton and
place them individually on a soft cloth to prevent
scratches or other damage.
Carefully and strictly follow these assembly instructions
to ensure a completed product as designed.
Do not use power tools above 8 volts to assemble.
C.
Side Panel
1 pc.
A.
Top
1 pc.
B.
Side Panel
1 pc.
J.
Shelf
1 pc.
F.
Back Rail
1 pc.
H.
Front Rail
1 pc.
M.
Drawer
1 pc.
K.
Door
1 pc.
L.
Door
1 pc.
N.
Towel Bar
2 pcs.
I.
Base
1 pc.
G.
Front Rail
1 pc.
Refer to later page(s) of these
instructions for drawer assembly.
E.
Back Upright
1 pc.
styles Customer Service: www.homestylesfurniture.com,home
[email protected], 888-680-7460
Hardware List
Part List
Small Hex Wrench
1 pc.
Hex Wrench
1 pc.
M6x30
Head Cap Bolt
1 pcs. (+1 extra)2
M3.5x25
Wood Screw (long)
8 pcs. (+1 extra)
M3.5x13
Wood Screw (short)
6 pcs. (+1 extra)
Handle
1.pc
M4x25
Machine Screw
4 pcs.
Knob
2 pcs.
Cam Lock Screw
6 pcs. (+1 extra)
Cam Lock
62pcs. (+ extra)
Caster
2 Locking
2 Non-Locking
4 pcs.
Adjustable Pin
41pcs. (+ extra)

Assembly Instructions 2/6
STEP 1
Insert Cam Lock Screws
into pre-drilled holes in
Side Panels (B) and (C),
then tighten.
(See Figure 1)
Figure 2
Cam Lock Screw
Head Cap Bolt
IMPORTANT
·Use a soft cloth between these parts and the floor.
Do not use power tools above 8 volts to assemble.·
Do not tighten all the bolts until each part is properly assembled.·
Keep Hex Wrench as the bolts may need to be tightened in the future.·
BC
I
B
Figure 1
STEP 2
Attach Base (I) to Side Panel (B) with Head Cap Bolts.
(See Figure 2)

Assembly Instructions 3/6
H
Cam Lock
STEP 3
Attach Back Panels (D), Back Upright (E)
and Back Rail (F) to unit with Cam Lock.
(See Figure 3)
Figure 3
D
D
E
F
STEP 4
Attach Front Rails (G) and (H) to unit with Cam Locks.
G
Cam Lock

Assembly Instructions /46
STEP 6
Turn unit upside down.
Attach Casters to bottom of unit,
with Locking Casters at front.
(See Figure 4)
Figure 4
Locking Caster
Non-Locking Caster
STEP 5
Attach Side Panel (C) to unit
with Cam Locks and Head Cap Bolts.
Cam Lock
Head Cap Bolt
C

Assembly Instructions /56
Part List
Drawer ( )M
M2.
Drawer Back
1.pc
M5.
Drawer Bottom
1.pc
M1.
Drawer Front
1.pc
M3.
Drawer Side
1.pc
M4.
rawer SideD
1.pc
STEP 9
Attach Handle with Machine Screws.
STEP 8
Slide Drawer Bottom ( 5) into groove.M
Attach Drawer Bottom ( 5) toM
unit with Wood Screws (short).
STEP 7
Attach Drawer Front ( 1) and DrawerM
Back ( 2) to Drawer Side ( 3)MM
with Wood Screws (long).
Attach Drawer Side ( 4) to unitM
with Wood Screws (long).
Wood Screw (short)
Wood Screw (long)
Bottom
M5
Roller at back
Machine Screw
Handle
M1
M4
M3
M2
Bottom
BottomBottom

Assembly Instructions /66
STEP 10
Turn unit to its upright position.
Attach Towel Bars (N) to
unit with Head Cap Bolts.
Attach Top (A) to unit with
Head Cap Bolts.
Insert Adjustable Pins into
side panels at desired level.
Place Shelf (J) into position.
Adjustable Pin
STEP 11
Attach Doors (K) and (L)
to unit by sliding door hinges
into side panel hinges.
(See Figure )5
Attach Knobs to Doors (K) and (L)
with Machine Screws.
(See Figure )6
Slide Drawer (M) into place.
Knob
Machine Screw
Head Cap Bolt
K
N
N
L
Figure 6
Figure 5
A
J
M

NEVER
use glass cleaners on
finished furniture. Ammonia
chemically attacks the finish.
allow liquids to remain on furniture.
Absorption causes parts to warp
and split and finishes to delaminate.
NEVER
CARE INSTRUCTIONS
Do not use rubber
based placemats.
PREVENT
DISCOLORING
Do not use commercial
waxes and polishes.
PREVENT
YELLOWING
Do not place hot
objects on surface.
PREVENT
FINISH DAMAGE
Do not write
directly on surface.
PREVENT
MARKING
Do not use power tools
above 8 volts to assemble.
PREVENT
CRACKING
Do not place
in direct sunlight.
PREVENT
FADING
with a soft cloth moistened
in lukewarm soap and water.
Buff with a dry clean cloth.
CLEAN
homestyles will provide replacements free of charge for missing or damaged parts within 30 days of purchase.
Digital images of the defective parts may be required. If the product was not purchased from an authorized retailer,
homestyles is under no obligation to provide replacement parts. Parts are not available for fully assembled items nor
are parts available for sale. Replacements for missing or damaged parts may be requested via contact info below.
styles Customer Service: www.homestylesfurniture.com,home
[email protected], 888-680-7460