Honeywell AlarmNet 7845GSM User manual

Step Mount
2
Step Check Signal Strength
1
1C
3C
3C
Connect AC transformer
Plug in the transformer to an available AC source
Check that signal strength is at least 3-5 bars lit
solid at mounting location
Unplug the transformer
A
B
C
D
GYGGRY
Min. Lit
ON
Signal Strength (RSSI) Function LED Display
Step Power Up and Program
4
Plug in transformer to a 120V AC source
Power up control panel
Check that module is in ECP mode. Press and hold RSSI/Mode
status switch. Red LED and both Yellow LEDs should be off.
(Refer to Installation and Setup Guide if using any other mode)
Use the web-based programming tool on the AlarmNet Direct
website or the 7720P Programmer to complete programming
(see Installation and Setup Guide for instructions)
Step Wire
3
Connect control panel wiring
– 12VDC in (red)
– GND (black)
– ECP input (yellow)
– ECP output (green)
7845i-GSM only – Connect Ethernet port to router – the Ethernet
has been detected when the right-most LED is lit in the network
connectivity LCD display
Place the battery inside the case back
– Snap the battery clip onto the right side of the case back and
secure the left side with the screw provided
– After all wiring connections have been made, connect battery
cables to the battery terminals
– Connect battery cable to connector J1
Step Register
5
All Honeywell GSM modules are pre-activated with the
cellular carrier
The GSM module requires an AlarmNet-i account and may
be registered by one of the following methods:
– Via web-based programming on
https://services.alarmnet.com/alarmnetdirect
– Via 7720P Programmer
– By calling AlarmNet Technical Assistance at 1-800-222-6525
When replacing 7845C series modules, registration may be
done by entering a PIN number
See Installation and Setup Guide for complete instructions
7845i-GSM shown at actual size
GYGGRY
OFF
OFF
RSSI/Mode Status Indicator Switch
1A
Zone 6 Input
Zone 7 Input
Fault Output to
Panel Zone Input
Connection for
7720P Programmer
EOLR
AC Transformer
Internal antenna
Tamper
switch Connector
J1 for
LEDs: Status (green)
Message (yellow)
Fault (red)
AL06016
L/GSMiSTEP/D
© 2006 Honeywell International Inc.
Quick Set-Up Guide for 7845GSM/7845i-GSM Modules
MOUNTING
SCREW (4)
(TYP)
WALL OR
MOUNTING
SURFACE
INTERNAL
ANTENNA
TABS
CASE
FRON
T
CASE
BACK
RSSI
M0
M1
GPRS
IBS
A
B
C
A
B
C
D
3A
3B
4B
4C
Control ECP
Terminals