Honeywell oneWireless XYR 6000 User manual

Sept 2009 XYR 6000 24V External Module Replacement 1
XYR 6000 Wireless Transmitters
24V External Power Module replacement
Order Part No. Qty. Description
50031428-501 1 24 Vdc Power Supply Module
Document Number Form: 34-XY-33-10
Effective Date: September 2009
When to replace
When the transmitter displays LOW PWR and external power is present and sufficient. When the external power
is removed to allow replacement of the module, all transmitter data is retained in the transmitter’s nonvolatile
memory.
Tools required
•#1 Phillips Screwdriver or 1/8” Slotted Screwdriver
•Torque Screwdriver
•1.5 mm hex key
WARNINGS
ATTENTION
24V power module must be replaced only by a trained service technician.
WARNINGS
•Risk of death or serious injury by explosion. Do not open transmitter
enclosure when an explosive atmosphere is present.
SHOCK HAZARD
•Depending on your installation, transmitter input wiring sources may contain high
voltage. Disconnect all power from transmitter input sources before accessing the
24V power module. Failure to do so could result in death or serious injury if the
input terminals or wires are accidentally touched.

2 XYR 6000 24V External Module Replacement Sept 2009
Figure 1. 24V Power Supply Module Assembly
M3 Locking
Screw
24V Wiring Connector
Power Connector
Power Module
Mounting Screws

Sept 2009 XYR 6000 24V External Module Replacement 3
Procedure
Figure 2, 24V External power module
Step Action
1 Loosen the M3 locking set screw on the end-cap (opposite end from display). Unscrew and
remove the end cap.
2 Using thumb and forefinger squeeze the power connector at top and bottom to disengage the
locking mechanism then pull to disconnect.
3 Unplug the 24V wiring connector from the module
4 Loosen the two 24V power module retaining screws. The screws are captive.
5 Pull the 24V power module out of the transmitter.
6 The replacement 24V Power Modules are supplied with the “J2” Jumper in the NON-RTD
position. For 24V Transmitters utilizing RTD sensors, move the “J2” jumper to the “RTD”
position on the power module. (Ref.Figure 2)
7 Insert the replacement 24V power module into the transmitter. Reattach the screws and tighten
to 0,4 – 0,6 N-M (3.5 – 5.3 Lb-in).
Re-connect power and 24V connectors
Honeywell recommends lubricating the end cap O-ring with a Silicone Grease such as Dow
Corning #55 or equivalent before replacing the end cap.
8 Screw the end cap back on and tighten the M3 locking screw.
9 Dispose of the Power Module according to local regulations
J2 Connector