HP HPE FlexNetwork 7500 User manual

Manual Version: 6P101-20160216 BOM: 3123A17N Part number: 5998-7205R
1
HPE FlexNetwork 7500 48-port 1000BASE-T SE
Module - LSQM1GT48SE0 (JH212A, JH220A)
1 Card identifier
The card identifier LSQM1GT48SE0 is at the upper right of the front panel.
2 Specifications
IMPORTANT:
Before installing the card, you must remove the protection cover from the card.
Table 1 Card specifications
Item Specifications
Card size (H × W × D) 40 × 399 × 352 mm (1.57 × 15.71 × 13.86 in)
Power consumption 38 W to 48 W
Net weight 3.18 kg (7.011 lb)
Connector type RJ-45
Ports 48
Port rate
10/100/1000 Mbps
NOTE:
The 10/100/1000BASE-T copper ports do not support half-duplex
configuration or autonegotiation.
Transmission medium and max
transmission distance 100 m (328.08 ft) over Category 5 or higher twisted pair cables
Applicable hardware platforms All 7500 models.
NOTE:
To verify compatibility of the card with the software release you are using, see the release notes.
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
PIN #8
PIN #1

Manual Version: 6P101-20160216 BOM: 3123A17N Part number: 5998-7205R
2
Table 2 RJ-45 GE connector pin assignment
Pin 10BASE-T/100BASE-TX/1000BASE-T
Signal Function
1 MX_0+ Transmits and receives data
2 MX_0- Transmits and receives data
3 MX_1+ Transmits and receives data
4 MX_2+ Transmits and receives data
5 MX_2- Transmits and receives data
6 MX_1- Transmits and receives data
7 MX_3+ Transmits and receives data
8 MX_3- Transmits and receives data
3 Obtaining documentation
For card installation, see HPE FlexNetwork 7500 Switch Series Installation Guide.
For software upgrade, see HPE FlexNetwork 7500 Switch Series Software Upgrade Guide.
To access documentation and support services, go to the Hewlett Packard Enterprise Support
Center website:
www.hpe.com/support/hpesc
The information in this document is subject to change without notice.
© Copyright 2016 Hewlett Packard Enterprise Development LP
5998-7205R