HP 705 Quick start guide

2–GB, 4–GB and 9–GB Ultra
Wide SE Disk Drive User Notes
Refer to your workstation owner’s guide or your disk drive installation
guide for detailed information about installing your disk drive. During
the installation procedure, you may have to change the SCSI ID of your
disk drive. Refer to the appropriate illustration to set the SCSI ID
jumpers to the desired SCSI ID.
NOTICE: We recommend that you use SCSI ID 6 for your
workstation’s first hard disk drive, and SCSI ID
5 for the second hard disk drive.
  
The 2–GB, 4–GB, and 9–GB disk drives are fully operational with HP-
UX Release 10.20 ACE (February 1998 or later). No additional software
patches are required.
The HP part numbers for these drives are:
Drive Exchange Part No. Spare Part No.
2–GB A1658–69020 A1658–60020
4–GB A1658–69021 A1658–60021
9–GB A1658–69024 A1658–60024
Part Number A1658–90715
Edition E0498
Printed in U.S.A.


CAUTION
NOTDo
plugs for J2 on J6.
You will damage the
internal contacts
use the jumper
A2 A1 A0
0
1
2
3
4
5
6
SCSI
J6
J2
M
S
B
L
S
B
ID
A3
8
9
10
11
12
13
14
15
Highest
Priority
Lowest
Priority
Term Power From Drive
Seagate ST34371W, ST34572W Disk Drive Jumpers (4GB)
Seagate ST32171W, ST32272W Disk Drive Jumpers (2GB)
A2
A1 A0
0
1
2
3
4
5
6
SCSI
ID
A3
8
9
10
11
12
13
14
15
Highest
Priority
Lowest
Priority
IBM DDRS–34560 Disk Drive Jumpers (4GB)
IBM DDRS–39130 Disk Drive Jumpers (9GB)