HPRT MPT8 User manual

Quick Start Guide
Packing List
Power Cord
Printer Quick Start Guide
USB Cable
Open the Printer Cover
Appearance
Close the Printer Cover
Ribbon CD
Front
Inside
Control Panel
Power Buon
Display Screen
Feed Buon
USB Interface Connector
Power Connector
Printer Cover
Cover Open Buon
Paper Entry Slot
Paper-end Sensor
Print (Thermal) Head
Paper Feed Posion Sensor
Press the le and right cover open buons with both hands
simultaneously and li the printer cover.
Press down the le and right sides of the printer cover to close
the cover.
Standard Accessories
Note: The power adapter and power cord vary by local or
region.
The packing materials are actually dependent on the order
MPT8/MPT8E
Oponal Accessories
Power Adapter
Car Kit Power Adapter
Xiamen Hanin Electronic Technology Co.,Ltd.
ADD: Room 305A, Angye Building, Pioneering Park,
Torch High-tech Zone, Xiamen, China 361009
TEL: [phone]
FAX: [phone]
WEB：www.hprt.com

Loading Ribbon Loading Media
1.Open the printer cover.
2.Hold the le and right ribbon’s handhold vanes, then insert
the ribbon as shown and push the ribbon down unl it clicks.
Handhold Vane
3.Rewind the ribbon feed mechanism to make it smooth.
4.Close the printer cover.
1.Make sure the ribbon is properly loaded and the cover of the
printer is closed.
2.Turn the printer power on. Touch power buon for
about 2 seconds.
3.Put the paper into the paper entry slot in parallel.Printer will
feed a distance automacally aer it detects the paper. A
buzzer will sound once when paper is successfully loaded,
otherwise the operaon is wrong.
Removing Media Connect the Power Supply
Cauon:
Do not pull the paper out forcefully while the printer cover is
closed, Otherwise may cause damage. Please remove the paper
according to follow steps:
1.Open the printer cover.
2.Pull the media out of printer in either direcon.
AC Power Cord
AC Adapter
1.Connect the power cord to the adapter.
2.Connect the adapter to the power connector of the printer.
3.Plug the power cord into a power outlet.
Connect the USB Interface
3.Close the printer cover.
4.Insert a new sheet of media and print again.
Welcome...