Huffy 214994B User manual

105/03 P/N 214994B
© COPYRIGHT 2000 by HUFFY SPORTS
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
Portable System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
Read and understand
operator's manual before
using this unit.
Failure to follow operating
instructions could result
in injury or damage to
property.
REQUIRED TOOLS AND MATERIALS:
• Two People
• Wood Board (Scrap)
• Tape Measure
• Step Ladder 8 ft. (2.4 m)
• Tape
• Garden Hose or Sand 360 lb. (163 kg)
• Hammer
• Wrenches: (Two) 1/2”, (One) 9/16” or Two Small
Adjustable Wrenches (9/16” Deep Socket
w/Extension Recommended)
• Support Table

2
P/N 214994B 05/03
WARNING
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT
IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
Owner must ensure that all players know and follow
these rules for safe operation of the system.
• DO NOT HANG on the rim or any part of the system
including backboard, support braces or net.
• During play, especially when performing dunk type
activities, keep player's face away from the backboard, rim
and net. Serious injury could occur if teeth/face come in
contact with backboard, rim or net.
• Do not slide, climb, shake or play on base and/or pole.
• After assembly is complete, fill system completely with
water or sand and stake to the ground. Never leave system
in an upright position without filling base with weight, as
system may tip over causing injuries.
• When adjusting height or moving system, keep hands and
fingers away from moving parts.
• Do not allow children to move or adjust system.
• During play, do not wear jewelry (rings, watches, necklaces,
etc.). Objects may entangle in net.
• Surface beneath the base must be smooth and free of
gravel or other sharp objects. Punctures cause leakage and
could cause system to tip over.
• Keep organic material away from pole base. Grass, litter,
etc. could cause corrosion and/or deterioration.
• Check pole system for signs of corrosion (rust, pitting,
chipping) and repaint with exterior enamel paint. If rust has
penetrated through the steel anywhere, replace pole
immediately.
• Check system before each use for proper ballast, loose
hardware, excessive wear and signs corrosion and repair
before use.
•Check system before each use for instability.
• Do not use system during windy and/or severe weather
conditions; system may tip over. Place system in the
storage position and/or in an area protected from the wind
and free from personal property and/or overhead wires.
• Never play on damaged equipment.
• See instruction manual for proper installation and
maintenance.
• When moving system, use caution to keep mechanism from
shifting.
• Keep pole top covered with cap at all times.
• Do not allow water in tank to freeze. During sub-freezing
weather add non-toxic antifreeze, sand or empty tank
completely and store. (Do not use salt.)
• Use extreme caution if placing system on sloped surface.
System may tip over more easily.
201241 2/99
In the U.S.:1-800-558-5234 and Canada: 1-800-284-8339

05/03 P/N 214994B
3
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
Owner must ensure that all players know and follow these rules for safe operation of the system.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check
entire box and inside all packing material for parts and/or additional instruction material. Before beginning
assembly, read the instructions and identify parts using the hardware identifier and parts list in this
document. Proper and complete assembly, use and supervision are essential for proper operation and to
reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed,
maintained, and operated properly.
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this system.
• If using a ladder during assembly, use extreme caution.
• Two (2) people are recommended for this operation.
• Check base regularly for leakage. Slow leaks could cause system to tip over unexpectedly.
• Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to
separate during play and/or transport of the system.
• Climate, corrosion or misuse could result in system failure.
• Minimum operational height is 6'6" (1.98 m) to the bottom of backboard.
• This equipment is intended for home recreational use only and NOT
excessive competitive play.
• Read and understand the warning label affixed to pole. Label is shown to the right.
• The life of your basketball pole depends on many conditions. The climate, placement of the pole, the
location of the pole, exposure to corrosives such as pesticides, herbicides or salts are all important.
• If technical assistance is required, contact Huffy Sports.
• Adult supervision is recommended when adjusting height.
200439 11/00
1
3
2
MOVING SYSTEM
1. While holding pole, rotate
basketball system forward
until wheels engage with
ground.
2. Move basketball system to
desired location.
3. Carefully rotate basketball
system upright.
4. Reattach ground restraint and
check system for stability.
HEIGHT ADJUSTMENT
A
WARNING
Backboard
may rotate during
height adjustment.
B
WARNING
Do not adjust height of system
in upright position. System must
be in down position to adjust
Rest unit on support table. Remove adjustment knobs (A)
and carriage bolts (B) to extend or retract backboard and rim.
Height adjustment from 7 1/2' to 10'.
15

4
P/N 214994B 05/03
For more information on assembly, placement, proper
use and maintenance, visit The American Basketball
Council website at http://www.smarthoops.com.
IMPORTANT!
Remove all contents from boxes.
Be sure to check inside pole sections;
hardware and additional parts are packed inside.
NOTICE TO ASSEMBLERS
ALL Huffy Sports Basketball Systems, including those used for DISPLAYS, MUST be assembled
and ballasted with sand or water according to instructions. Failure to follow instructions could
result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.
WARRANTY CARD:
Please remember to complete your product
registration form either on-line at:
www.huffysports.com/warrantycard or
mail-in the enclosed postcard.

05/03 P/N 214994B
5
Get to know the basic parts of your basketball system.....
STRUTS
BACKBOARD
FRONT
RIM
WHEEL
CARRIAGE
ASSEMBLY
BASE
POLE

6
P/N 214994B 05/03
PARTS LIST - (See Hardware Identifier)
Item Qty.Part No. Description
1 1 206645 Tank (Black)
2 1 200628 Wheel Axle
3 2 226401 Wheel
4 1 900060 Top Pole Section
5 1 908480 Middle Pole Section with Label
6 1 908490 Bottom Pole Section
7 1 202820 Rod, 3/8 O.D. x 4-3/4 Long
8 1 202822 Eye Bolt, 3/8 x 16 x 3-3/4 Long
9 1 200627 Wheel Bracket
10 1 203063 Lock Nut, Nylon Insert, 3/8-16
11 1 201625 Bolt, Hex Head, 5/16-18 x 3-3/4
12 6 203218 Washer, 5/16 Flat
13 2 906206 Tank Strut
14 1 203220 Lock Nut, 5/16-18
15 1 200439 Label, Moving System and Height Adjust.
16 2 203156 Bolt, Hex Head, 5/16-18 x 1 Long
17 6 203100 Nut, Hex Flange 5/16-18
18 1 Rim
19 12 201219 SmartClip, Net Holder
20 2 900057 Backboard Mounting Bracket
21 4 203309 Washer, 1 O.D.
22 4 203113 Bolt, Hex Flange, 5/16-18 x 2-1/2 Long
23 2 203231 Bolt, Carriage 5/16-18 x 3-1/2
24 2 203435 Knob, Plastic, 1-3/4 Diameter
25 1 Net
26 1 206219 Cap
27 1 203124 Tie Down Stake
28 2 201651 Spacer, Wheel Axle
29 1 200629 T-Strap
30 1 203617 Tank Cap
* YOU MAY HAVE EXTRA PARTS WITH THIS MODEL.

05/03 P/N 214994B
7
HARDWARE IDENTIFIER
Item #14 (1)
Item #12 (6)
Item #10 (1)
Item #19 (12)
Item #16 (2) Item #17 (6)
Item #21 (4)
Item #28 (2)
Item #22 (4)
Item #23 (2)
Item #8 (1)
Item #11 (1)
Item #7 (1)

8
P/N 214994B 05/03
TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION
(not actual size)
SECTION A: ASSEMBLE THE BASE
9/16” and 1/2”
9/16” and 1/2”
AND/OR
This is what your system will look like
when you’ve finished this section:
Item #14 (1)
Item #12 (6)
Item #10 (1)
Item #16 (2) Item #17 (6) Item #21 (4)
Item #28 (2)
Item #8 (1)
Item #11 (1)
Item #7 (1)

05/03 P/N 214994B
9
1.
1
Remove contents from tank
5”
(13 cm)
2. Correctly identify each pole
section and mark indicated
distance from ends with tape
(not supplied) as shown.
3. IMPORTANT! Center the alignment slot of middle pole section (5) in the
lower hole of top pole section (4) as shown. While maintaining alignment,
bounce middle section of pole (5) into top section of pole (4) using wood scrap
as shown until they no longer move toward taped reference mark.
NOTE: Pole sections should have a 3-1/2" (9 cm) minimum overlap.
5”
(13 cm)
WOOD SCRAP
(NOT SUPPLIED)
5
4
TAPE (Not Supplied)
TOP
MIDDLE
BOTTOM
4
6
5

10
P/N 214994B 05/03
4
5
6
WOOD SCRAP
4. IMPORTANT! Center the alignment slot of lower pole section (6) in the lower
hole of middle pole section (4) as shown. While maintaining alignment, bounce
top and middle pole assembly (4 & 5) onto bottom section of pole (6) using wood
scrap as shown until they no longer move toward taped reference mark.
NOTE: Pole sections should have a 3-1/2" (9 cm) minimum overlap.
6
5
5. Install rod (7) through holes in bottom pole section (6) and eyebolt (8).
8
7
6
8
7
4
65