Huffy Single Electronic Basketball System User manual

111/03 P/N 211483E
© COPYRIGHT 2000 by HUFFY SPORTS
Toll-Free Customer Service Number for U.S: 1-800-558-5234,
For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234),
For Australia: 1-800-333 061
Internet Address: http://www.huffysports.com
Dual Electronic Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO PROPERTY.
WARNING!
Tools Supplied:
1 Allen Wrench
1 Phillips Screwdriver
1 Wrench 7/16
1 Wrench5/16
Tools Needed:
4 "D" Cell Batteries

2
P/N 211483E 11/03
IMPORTANT!
Remove all contents from boxes.
We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with
your selection. Although great care and effort have been taken, occasionally problems may occur. To ensure
prompt and correct handling of any problems, or to answer any questions, please contact our Toll-Free Customer
Service Number listed on front page. Service will be quicker if you have your Model Number
(found on carton) and assembly instructions ready when calling.

11/03 P/N 211483E
3
Get to know the basic parts of your basketball system.....
SUPPORT
POLES
BACKBOARD
FRONT
TARP
RIMS

4
P/N 211483E 11/03
PARTS LIST - (See Hardware Identifier)
Item Qty P/N Description
1 2 200745 Net Hanger Tubes
2 2 200746 Board Mounting Vertical Support Tube
3 2 200747 Vertical Support Tube
4 1 200748 Horizontal Cross Tube
5 1 200749 Horizontal Cross Brace
6 2 200750 90 degree corner Back Leg Support Tube
7 2 200752 Floor Mounting Support Tube, Short
8 2 200753 Angle Corner, Front Leg Support Tube
9 1 200754 Horizontal Front-Ramp Support Tube
10 2 200755 Front Ramp Support Tube
11 2 200756 Ramp Support Tube, Long
12 2 200757 Back Ramp Support Tube
13 1 Wood Backboard
14 1 Ball Ramp With Side Netting
15 1 200760 Electronic Score Keeper
16 2 200761 Switch And Paddle Assm
17 2 200762 12" Tubular Rims
18 1 200763 Red Plastic Display Lens
19 2 200764 Nylon Net
20 4 7" Rubber Ball
21 1 200766 AC Adapter
22 2 200767 Metal Back Plate
23 6 200768 Plastic Tube Caps
24 8 200770 #10 x 1 Phillips Head Bolt
25 8 200771 #10 Hex Nut
26 16 200772 Black Plastic Net Clips
27 8 200773 ¼ x 3 ½ Socket Head Screws
28 6 200774 ¼ x 2 ½ Socket Head Screws
29 8 200775 ¼ x 3/8 Socket Head Screws
30 8 200776 ¼ x 1.0 Socket Head Screws
31 32 200777 ¼" Flat Washer
32 20 200778 ¼" Flange Nut
33 10 200779 Washer, M5
34 1 200780 Allen Wrench
35 12 201936 Caps Screw
36 1 200972 Phillips Screwdriver
37 1 203358 Air Pump and Needle

11/03 P/N 211483E
5
Attach rims (17) to backboard (13)
with bolts (30), back plates (22),
and nuts (32) as shown.
Repeat for opposite side.
Attach score keeper (15) to backboard with bolts (24),
washers (33) and nuts (25). Attach lens (18) to front of
score keeper (15) as shown.
Attach nets (19) with net clips (26) as
shown. NET SHOULD REST IN SLOT
ON CLIP AS SHOWN FIG. B.
1. 2.
3.
32 13
17
30
15
24
18
22
Attach scoring paddles (16) onto backboard
below rims (17) with bolts (24) washers (33) and
nuts (25). Plug wires from paddles into scoring
unit as shown.
4.
19
16
16
17
24
25
25
24
33
33
33
33
26
FIG B.
DO NOT ENTANGLE WIRES FROM PADDLE IN NET
33
25

6
P/N 211483E 11/03
Assemble upper framework (1, 2, 23).Secure ball ramp (14) to outer framework as shown Fig. A.
Insert tube (5) through top of ball ramp(14) and attach backboard assembly to tubes 1,2 and 5
with hardware as shown. Repeat for opposite side. Insert horizontal front ramp tube (9) through
bottom of ball ramp (14) as shown.
5.
32
35
5
3
9
28
31
31
28
14
1
2
4
Fig. A
1
2
23

11/03 P/N 211483E
7
6. Assemble lower framework (6, 7, 8) using bolts (29) and washers (31). Attach to upper framework
as shown. Repeat for opposite side.
Assemble side rails (10, 11, 12) using bolt (29) and
washer (31). Install tube caps (23) as shown.
7.
6
7
8
29
3
9
23
23
10
11
12
29
31
27
32
32
35
35
27
Attach side rails using bolt (27) washer (31),
nut (32) and screw caps (35) as shown.
Repeat for opposite side.
31
31
31
IMPORTANT!:
Connect side rails
so that bolt heads
face inward.

8
P/N 211483E 11/03
1
Fasten elastic straps in locations shown.
Operation.
8.
9. BACK VIEW OF SCORING UNIT
VOLUME
CONTROL
ON/OFF AC
ADAPTER
DC BATTERY
COMPARTMENT
PADDLE CONNECTIONS
AC POWER: REMOVE AC ADAPTER FROM BOX. INSERT AC PLUG INTO SLOT ON SCORING UNIT. INSERT AC
ADAPTER INTO 110 VOLT WALL OUTLET. TURN SCORING UNIT “ON”.
DC BATTERY POWER: REMOVE BATTERY COVER FROM SCORING UNIT. INSERT 4 “D” CELL BATTERIES INTO
COMPARTMENT. REPLACE BATTERY COVER. TURN SCORING UNIT “ON”.
DISCONNECT AC POWER WHEN USING DC BATTERY POWER

11/03 P/N 211483E
9
Electronic Game Scoring
1. As a player steps up and sinks a basket, a musical tune will play to signal
the start of a game. After the tune stops and a beep is heard a 00 display
will show.
2. The score keeper will reset the display to 30 seconds and begin counting
baskets.
3. A beep is made for every basket made, a different pitch beep for each
player.
4. Two (2) points per basket made for first 20 seconds of game play.
5. After 20 seconds, a musical tone will play, signaling the start of 3 points per
basket.
6. As time displays 00, a buzzer will sound. The score is retained in memory for
each player.
7. If 30 points or more is scored a "CHARGE" tune will play, earning a 15
second bonus round for each player with each basket made scoring 3 points
8. If 60 points or more is scored, an additional 10 seconds is awarded for each
player. Each basket made scores 3 points
9. As the game is finished a 6 second delay will clear both scores and reset.
10. The highest score made is displayed and retained in memory. The high score
resets to 00 if game is not played after 30 minutes.
11. If an AC power adapter is used, the high score will be retained in memory
unless power is disconnected.