human care 1405 User manual

ASSEMBLY/USAGE LOOK SHOWER SEAT
Model #1405
Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)
OPERATING MANUAL
WARNINGS
Ensure legs are locked in before
sitting.
Ensure legs are adjusted to
be level before use to avoid
possible injury.
DO NOT stand on seat. Legs
must firmly touch the ground
when seated.
DO NOT exceed weight capacity!
250lb / 113.4kg
COMPONENTS
1 x Seat 4 x Legs
CARE AND USE
DO NOT use chlorine bleach or
abrasive cleansers. To clean, wipe
down with a damp cloth using a
mild detergent only. Rinse well
after each use.
Only use on tub/shower floors
that are wide enough to ensure
stability of all four legs.
Supervision or assistance when
using seats is recommended for
users with limited mobility.
READ ALL WARNINGS CAREFULLY
KEEP THIS INFORMATION FOR FUTURE
REFERENCE
Increase safety by using a slip
resistant bath mat under the seat.
Shower seats are not to be used
for assistance in entering/exiting
the bathtub. Use a bathtub safety
rail to assist you in sitting down if
necessary.
Periodically check the legs to
ensure that all push buttons
protrude fully through the
adjustment holes in the legs.
Ensure your weight is evenly
distributed when sitting.
Improper or uneven loading may
result in the bath seat tipping over
and/or falling.
Use only authorized parts/
accessories with your shower
seat.
SOLD SEPARATELY
DO NOT USE ANY PIECE IF THERE ARE ANY CRACKS OR DAMAGED
COMPONENTS

ASSEMBLY/USAGE LOOK SHOWER SEAT
Model #1405
Human Care Canada Inc. All rights reserved. This manual may not be reproduced in part
or in whole without the written permission of the publisher. (REV: SEPTEMBER 2013)
OPERATING MANUAL
STEP 1
Flip over seat and insert legs into holes
in bottom of seat, ensuring you hear the
white button “click” into place.
STEP 2
Push in brass coloured button and
slide inner tube up or down to adjust to
desired height. Ensure button “clicks”
into place.
ASSEMBLY
IMPORTANT: ENSURE THAT ALL PUSH BUTTONS “CLICK” INTO POSITION. DO NOT USE PRODUCT IF PUSH
BUTTONS ARE DAMAGED IN ANY WAY.
ADDING AN ARMREST / SMALL BACKREST
Add armrest to side holes on seat by pushing clips downwards into holes until
they “click” in. The armrest can be added to either side of the seat.
NOTE: When the bath seat is turned, the armrest acts as a small backrest.
IF YOU HAVE ANY PROBLEMS OR REQUIRE
ASSISTANCE WITH THE PRODUCT PLEASE
CALL:
613-723-6734
HUMAN CARE CANADA INC.
10-155 Colonnade Road
Ottawa, ON K2E 7K1
DISHWASHER
SAFE PLASTIC
ITEM SOLD SEPARATELY
STEP 3
Turn over seat after all legs installed and
verify they are evenly adjusted. Do not
use if seat is not level.