Human Touch iJoy-2310 User manual

troubleshooting guide Robotic Massage® Chair
175
iJoy
2310
iJoy

January 6, 2012
©2012 Human Touch, LLC. All rights reserved.
Please forward any questions or comments regarding this Troubleshooting Guide to
[email protected].

iJoy-2310 Troubleshooting Guide 1
iJoy-2310 Troubleshooting
This Troubleshooting Guide walks you step-by-step through the
diagnosis of iJoy-2310 customer problems. It is important to follow
these steps carefully, to ensure that the problem is diagnosed
correctly, and therefore the appropriate repair action is taken.
Getting Started
1. Unplug the chair, wait approximately five seconds, then plug it
back in.
2. Check whether any remote control LEDs light. If they do not, see
"Power" on page 2.
3. Choose from the following:
To Troubleshoot This
Issue Do the following:
My remote control is
not working
Power to remote has already been verified
therefore:
• If a remote LED does not light when you
press it, but the function it controls works,
replace the remote.
• If a remote LED lights when you press it, but
the function it controls does not work,
replace the backrest.
My chair is not
massaging properly
If the Rolling, Kneading, Percussion or
Compression massage is not working, or is
making a loud noise, replace the backrest.
My backrest won’t
recline/incline
• If there is tension when you pull the recline
handle, replace the backrest actuator
cylinder.
• If there is no tension when you pull the
recline handle, there is a problem with the
recline cable. Replace the chair.

2iJoy-2310 Troubleshooting Guide
Power
Step 1: Check the power and remote control cables
Verify that the power cord connections to the power panel are secure,
and that the cord is not damaged. If any of the power panel components
is damaged, replace the power panel.
IMPORTANT
Be sure to note the serial number on the power panel. Once
the power panel is replaced, the chair will no longer contain the
serial number on the power panel.
Step 2: Check the wall outlet
Plug a different device into the AC outlet into which the chair is plugged.
If the device does not work (is not receiving power), the AC outlet is
most likely not working. Plug the chair into a different AC outlet to verify
that it receives power.
Step 3: If the chair is still not receiving power, replace the
backrest

Human Touch, LLC
3030 Walnut Ave.
Long Beach, CA 90807
www.humantouch.com