Human Touch iJoy-2400 User manual

REMOVING THE WHEEL AND AXLE
1. Tip the chair gently forward, resting the headrest on the floor.
2. Insert a flat-head screwdriver between the wheel and the receptacle wall (Fig.1).
3. Use the screwdriver as leverage to pry the wheel loose, freeing the wheel and axle from the chair (Fig.2).
Tools Required: flat-head screwdriver to replace wheel/axle, Phillips-head screwdriver to replace wheel receptacle.
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions. SERVICE LEVEL: 1
IF YOU ARE REPLACING THE WHEEL RECEPTACLE:
1. Using a Phillips-head screwdriver, remove the rear receptacle screw/washer and the two screws on the bottom of the receptacle (Fig.2).
NOTE: Be sure not to lose the rear screw washer.
2. Place the new wheel receptacle into position, then replace the three screws, ensuring that the rear screw/washer is placed in the rear screw hole.
REPLACING THE WHEEL RECEPTACLE
X1103
REPLACING THE WHEEL/AXLE/WHEEL RECEPTACLE
Feb 04, 2010
iJoy-2400
(Fig.1)
Wheel
Receptable wall
Rear receptacle screw
Washer
Wheel receptacle
1
(Fig.2)

1. Insert the axle through the wheel, then insert the right-hand end of the axle into the hole on the right-hand side of the wheel well (Fig.3).
2. Align the left-hand end of the axle with the mounting groove on the left-hand side of the wheel well, then press firmly on the wheel to snap the axle into place (Fig.3).
3. Tip the chair gently back to an upright position.
INSTALLING THE NEW WHEEL AND AXLE
Please send any questions or comments regarding these instructions to: [email protected]
© 2010 Human Touch®, LLC.
(Fig.3)
Axel
Receptable wall
Axel
Axel
Wheel