HUSKY LINERS 2590FR Manual

2590FR~1.DOC
Rev: 0
12/19/00
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely
unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your vehicle
with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In colder
climates this “relaxing” may take longer; moving the liner to a heated area will accelerate the process.
Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The
easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use
of Armor All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR TOYOTA
RAV4 CARGO LINER
TO ACCESS THE FACTORY CARGO TIE DOWN HOOKS WITH YOUR LINER IN PLACE, MAKE A
SLIT ACROSS THE FOUR RAISED AREAS ON YOUR LINER (SHOWN ABOVE COMPLETELY
DARKENED). THEN, PUSH THE HOOKS UP THROUGH THE SLIT AS SHOWN ON THE PHOTOS
ON THE BACK OF THIS PAGE.
TO ACCESS THE FACTORY CHILD SAFETY SEAT TETHER POINTS,
TRIM AWAY THE MATERIAL FROM THE CORRESPONDING
RAISED AREA SHOWN CIRCLED ABOVE. TWO OF THE CARGO
TIE DOWN HOOKS ARE ALSO USED FOR TETHERING POINTS. A
UTILITY KNIFE WORKS WELL FOR TRIMMING.

2590FR~1.DOC
Rev: 0
12/19/00
RAV4 CARGO LINER PHOTOS SHOWING ACCESS TO CARGO TIE-DOWN HOOKS
AND CHILD SAFETY SEAT TETHERING POINTS
SHOWING LINER SLIT AND TIE-DOWN HOOK
PUSHED THROUGH TO ALLOW ACCESS
SHOWING RAISED AREA IN LINER TRIMMED
AWAY TO ALLOW ACCESS TO TIE-DOWN HOOK
SHOWING CENTER RAISED AREA IN LINER
TRIMMED AWAY TO ALLOW ACCESS TO THE
CHILD SAFETY SEAT TETHERING POINT