HUSKY LINERS 2628 Manual

2628_Insert.doc
04/29/2005
THANK YOU FOR SELECTING A HUSKY FLOOR LINER
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way
to clean your liner is with a damp cloth or sponge. If using a cleaner, 409®or Glass Plus®work well. Use of Armor
All®, Son-of-a-Gun®or similar items is discouraged as these products make the liner slick.
INSTALLATION INSTRUCTIONS FOR YOUR NISSAN XTERRA
CARGO LINER
IF YOUR XTERRA IS EQUIPPED WITH THE UTILI-TRACK CARGO CHANNEL SYSTEM, YOU CAN ACCESS
THIS OPTION WITH YOUR CARGO LINER IN PLACE. HERE’S HOW:
FIRST, NOTE THAT YOUR CARGO LINER HAS A MOLDED IN RIB THAT COMPLETELY SURROUNDS THE
AREA ABOVE EACH TRACK. SIMPLY TRIM THE TREAD PLATED MATERIAL (SHOWN ABOVE
DARKENED) FROM THE BOTTOM OF EACH OF THESE “MOATS” AND THEN INSTALL YOUR CARGO
LINER. THE MOATS WILL SURROUND THE TRACKS AND PREVENT LIQUID FROM RUNNING UNDER THE
LINER. A PHOTO OF THE TRIMMED PART IS SHOWN ON THE BACK OF THIS PAGE.
XTERRA’S COME EQUIPPED WITH SMALL CARGO NET THAT IS LOCATED DIRECTLY BEHIND THE
DRIVER’S SIDE WHEEL WELL. YOU CAN ACCESS THE TWO (2) CARGO NET ANCHORS WITH YOUR
LINER IN PLACE (AREAS SHOWN ABOVE CIRCLED). TO DO SO, SIMPLY REMOVE THE MATERIAL FROM
TWO LOWERED “U-SHAPED” AREAS IN FRONT OF THESE ANCHORS. A UTILITY KNIFE OR HEAVY
SHEARS WORKS WELL FOR TRIMMING.

2628_Insert.doc
04/29/2005
XTERRA CARGO LINER SHOWN TRIMMED FOR ACCESS TO UTILI-TRACK
CARGO CHANNEL SYSTEM